Vitek VT-3608 - Инструкция (Страница 5)

СХЕМА ПОДКЛЮЧЕНИЯ МАГНИТОЛЫ
СПЕЦИФИКАЦИЯ
Питание DC 12 В, отрицательное
заземление
Выходная мощность 4 х 25 Вт
Магнитофон
Система воспроизведения
4 дорожки,
2 направления
Скорость ленты 4,75 см/с
Взвешенное значение детонации 0,4%
Взвешенное значение сигнал/шум 40 дБ
Радиоприемник
FM диапазон
64 108 МГц
AM диапазон 540 1600 КГц
СРОК СЛУЖБЫ АВТОМАГНИТОЛЫ НЕ МЕНЕЕ 3 Х ЛЕТ
РУССКИЙ
12
9. LO/DX BUTTON
After power up, DX mode will be selected automatically, the radio is at highest sen
sitivity. When searching for stations in some areas where the stations are crowed,
select Local mode (LO) to receive the strongest stations only. When Local mode is
selected, the "LOC" symbol on the LCD will light up.
10. FM STEREO/MONO BUTTON
In some areas where FM stereo signal is not strong enough, background noises
will appear, in this case, select FM mono mode will reduce such noises. When an
FM stereo station is received and FM stereo mode is selected, the FM stereo indi
cator on the LCD will light up.
11. “OPEN” BUTTON
12. DISPLAY
13. “TAPE” BUTTON
MAINTENANCE
For System
The following suggestions help you care for the product so that you can enjoy it for
years.
1.
Keep the product dry. If it does get wet, wipe it dry immediately. Liquids might
contain minerals that can corrode the electronic circuits.
2. Keep the product away from dust and dirt, which can cause premature wear
of pans.
3. Handle the product gently and carefully. Dropping it can damage circuit
boards and cases, and can cause the product to work improperly.
4. Wipe the product with a dampened cloth occasionally to keep it looking new.
Do not use harsh chemicals, cleaning solvents, or strong detergents to clean
the product.
5. Use and store the product only in normal temperature environments.
High temperature can shorten the life of electronic devices, damage batteries,
and distort or melt plastic parts.
For Tape Player
Periodic cleaning of the tape head and capstan shaft will ensure good reproduc
tion of music and trouble free operation. Cleaning of the tape head should be
done every 20 to 30 hours of operation or when the high tones have become less
clear.
1.
Use a cassette cleaning cartridge if available. If one is not available, use a cot
ton swab soaked in isopropyl (rubbing) alcohol.
2. While holding the tape door open, locate tape head to the right of the opening
and in the centre of the unit.
5
ENGLISH
3608.qxd 12.02.03 11:08 Page 10