Beko GG 15120 DX - Инструкция (Страница 77)

A Risk of explosion by damage of
the safety tube!
The safety tube must not be
clamped, bent or trapped or
come into contact with hot parts
of the appliance.
Connection to the mains suppiy
[il This appiiance must be
earthed!
Our company shall not be held
responsible for any damage
caused by using the appliance
without earthed socket.
A
Risk of electric shock, short
circuit or fire by unprofessional
installation!
The appliance may be connected
to the mains supply only by an
authorized qualified person and
the appliance is only guaranteed
after correct installation.
A Risk of electric shock, short
circuit or fire by damage of the
mains lead!
The mains lead must not be
clamped, bent or trapped or
come into contact with hot parts
of the appliance.
If the mains lead is damaged, it
must be replaced by a qualified
electrician.
The mains supply data must
correspond to the data specified on
the rating plate of the appliance. The
rating plate is either seen when the
door or the lower cover is opened or it
is located at the rear wall of the
appliance depending on the appliance
type.
15
The supply cable of the appliance
must correspond to the specifications;
see technical data table
Technical
specifications, page 5.
[D The plug should be easily
accessible after installation (but
not above the hob).
Plug the mains lead into the socket.
^ Risk of electric shock!
Before starting any work on the
electrical installation, please
disconnect the appliance from
the mains supply.
• Position appliance up to the
kitchen wall.
• Securely attach safety chain to the
wall behind the cooker.
• To align the appliance with the
worktop, adjust the feet turning
right or left hand as required.
• Installation of the oven feet
Four feet are supplied with the
appliance.
Each foot should be mounted to
the housings placed on all corners
of the bottom.
The appliance must be lifted to a
sufficient height in order to allow
easy fitting of the feet. A minimum
of two people is recommended for
this operation. If you are resting
the product on something please
ensure that there is adequate
support across all of the base of
the appliance.
Place the screwed side of the foot
to the housing and screw
clockwise direction.
For your safety,adjust the feet so
that the cooker is level (use a spirit
level to check) There is a risk of
burning, pots and pans spilling or
EN