Beko CE 56100 - Инструкция (Страница 63)

Oven interior
Before switching on again ensure that all controls are in the OFF
position. Take out all trays and the grill out of the oven. Clean
out the interior with a piece of moist, soapy cloth. Then, clean
it once more with a wet piece of cloth and let it to dry.
Do not use dry powder agents for cleaning.
Special cleaners that are commercially available may be used
after carefully reading the warning that are written on the labels.
Warning!
Never clean the inside of the oven and trays with hard brushes,
steel pads or knives.
Special cleaners that are commercially avaible may be used after
carefully reading the warning that are written on the labels.
Catalytic-enamelled models; The oven interior of
this model is coated with catalytic enamel since the catalytic
enamel cleans itsellf, you do not have to perform an extra
cleaning after the cooking operation.
If your oven obtains steel rack;
To clean the steel rack, unscrew the 4
screws. After cleaning operation, assemble
the steel rack to the oven body again.
Control panel
Wipe over the control panel with a damp cloth and polish with a dry
cloth. Do not use oven cleaners or aerosols, scouring pads or abrasive
powder for cleaning the plastic knobs as damage will occur. Do not
attempt to remove any of the control knobs from the panel as this
may cause damage and is a safety hazard.
Oven door
Wipe over the door outer panel with a cloth wrung out in hot soapy
water, then after wiping with a
cloth wrung out in clear water. Do not use scouring pads or abrasive
powder which may scratch the surface. Take care during cleaning
not to damage or distort the door seal.
Replacing the oven lamp;
( if available )
1. Unplug the power cable.
2. Then, remove theprotective
glass cover of the lamp inside
your oven by turning it
counterclockwise.
3. Then, remove the bulb by
turning it counterclockwise.
4. After installing the
correct bulb obtained
from an Authorized Service
, reinstall the protective glass of the lamp.
29