Moдель: tt2 – Инструкция по эксплуатации Mongoose TT2

Страница 10

Advertising
background image

Car Alarm System MONGOOSE TT2.

13

ENGLISH

that the Wait to Anti Hi jack period is turned on, the Anti Hi jack will start as soon as the
door is open.

To have option a) the User’s Function 1 7 is to be ON, to have option b) the User’s Function

1 7 is to be set to “One Trip Anti Hi jack” option.

Anti Hi Jacking Mode Deactivated

The Anti Hi Jacking mode is completely deactivated when Anti Hi jacking mode function

is off, and button 3 of the transmitter has not been pressed with the ignition on or pressed 2, 4,
6, … times.

Anti Hi Jacking Mode is switched ON

If the Hi jacking mode is set either by programming or by pressing button 3 of the transmitter

it will operate as follows:

1. After a door is opened with the ignition switched on the LED will start to flash, this is a 30

second Grace period to allow you to enter units digit of the PIN code or press the passive
Immobiliser disarm button (buttons). As soon as the incorrect transmitter button is pressed
twice the transmitter operation will be blocked for 2 minutes as well as if the incorrect code
is entered a second time then the PIN code procedure will be blocked for 2 minutes.

2. After the Grace period the siren will start beeping to remind you the system entered the

Anti Hi Jack mode. This Warning period lasts 30 seconds and you can exit the Anti Hi
jack with units digit of the PIN code entered in the same way as while in the Grace period
or with the passive immobiliser disarm button pressed. As soon as the incorrect transmitter
button is pressed twice the transmitter operation will be blocked for 2 minutes as well as the
incorrect code is entered a second time, then the PIN code procedure will be blocked for
2 minutes

3. After the warning period, the indicators will flash and the siren will sound.
4. The siren will continue to sound and the immobiliser depending on the setting of the

Installer’s Function 1 8 will either remain disengaged until the ignition is switched off or
operate in accordance with the Blocking in Trouble Simulation procedure.

5. As soon as the ignition is turned off, the immobiliser will engage, the siren will stop

sounding but the indicators will continue to flash.

6. To exit the Anti Hi jacking procedure, you must enter the PIN code using the override

switch. All transmitters will be ignored during the Anti Hi jacking procedure.

The following PIN code procedure should be used to exit the Anti Hi Jack:

Grace and Warning Periods with the ignition on:

a) Press the override switch the number of times equal to units’ digit of the PIN code.
b) Wait 3 seconds to ensure the override switch is not pressed again.
c) If the code is correct exit Anti Hi jacking mode and if it is not, continue with the Grace

(or Warning) period. Entering an incorrect code will not effect the 30 second Grace (or
Warning) period.

d) If an incorrect PIN code is entered twice in succession, then the PIN code procedure will

be blocked for 2 minutes. If you press the wrong transmitter button twice the transmitter
operation will also be blocked for 2 minutes.

Руководство пользователя

Moдель: TT2

28

Для отключения охраны с заведенным двигателем по варианту 1 нажмите кнопку 2, а

затем кнопку 1, сигнализация снимется с охраны, поддержка зажигания выключится.

Вариант 2. Чтобы поставить сигнализацию на охрану при заведенном двигателе с

требованием продолжения работы двигателя после снятия с охраны, выполните следую
щую процедуру:

1. При включенном зажигании и закрытых дверях нажать и удерживать нажатой

примерно 3 секунды кнопку 2.

2. Короткий звуковой сигнал подтвердит активизацию выхода поддержки зажигания

(если звуковые сигналы подтверждения не отключены программно).

3. После звукового сигнала выключите зажигание, выйдите из автомобиля и закрой

те дверь.

Внимание! При активированной функции Anti Hi jack, открыв дверь, сначала введите

кнопкой аварийного отключения младший разряд PIN кода или нажмите комбинацию
кнопок на брелоке, запрограммированную для отключения пассивного иммобилайзера,
чтобы отключить Anti Hi jack.

Помните, что отключение Anti Hi jack при открытой двери, отключает его активи

зацию от открытия двери до следующего включения зажигания.

4. Нажмите кнопку 1 пульта управления.
5. Включится режим охраны. Включение режима система подтвердит звуковым и

световым сигналом. На время охраны с заведенным двигателем датчики и блоки
ровки будут отключены.

ПРИМЕЧАНИЕ: Во избежание ошибочного включения режима во время движения авто

мобиля его активизация разрешается системой только после открытия и закрытия двери
при включенном зажигании.

Для отключения охраны с заведенным двигателем по варианту 2 нажмите кнопку 2,

сигнализация снимется с охраны, но поддержка зажигания останется включенной. Для
отключения поддержки зажигания нажмите на 3 секунды кнопку 2 после снятия сигна
лизации с охраны.

Независимо от варианта включения охраны с заведенным двигателем его продолжитель

ность не может быть более 10 минут. По истечении 10 минут поддержка зажигания
выключится. После выключения зажигания сигнализация перейдет в режим полной охраны.
Если в течение 10 минут работы поддержки зажигания включилась тревога, поддержка
автоматически выключается и сигнализация переходит в режим полной охраны, при вык
лючении зажигания включается блокировка двигателя .

После включения по любой причине режима полной охраны для снятия с охраны нажмите

кнопку 2.

При программно включенной функции пассивного иммобилайзера, после снятия систе

мы с охраны режим иммобилайзера будет активирован, однако блокировка двигателя
включится только после выключения (по любой причине) зажигания. Об отключении
режима иммобилайзера читайте в разделе Режим пассивного иммобилайзера.

Advertising