Petsafe SPT-85 Spray Commander™, 85 m Basic Remote Spray Trainer - Инструкция (Страница 116)

116 www.petsafe.net
.
FI
SV
DA
NO
RU
EN
Receiver Collar LED – Function and Response
Receiver Collar
Function
LED Response Receiver Collar
Beeper Response
Receiver Collar is turned on Green LED flashes one time Beeps low to high
Unit is on Green LED flashes once every five
seconds
None
Spray activation Red LED flashes between sprays when
Spray Button is held down
None
Low battery condition Red LED flashes three times every five
seconds
None
Tone being received Green LED flashes Tone beep
STEP 3
Fit the Receiver Collar
Important: The proper fit and placement of your Receiver Collar is
important for effective operation.
To assure a proper fit, please follow these steps:
1. Make sure that the Receiver Collar is turned off.
2. Start with your dog standing comfortably ( 3A ).
3. Place the Receiver Collar on your dog’s neck close
to the ears. Centre the unit underneath your dog’s
neck, touching the skin ( 3B ). Make sure the PetSafe ®
logo on the front of the unit is upright. Note: It is
sometimes necessary to trim the hair along the path
of the spray. It is important that the spray reaches
your dog’s snout to be effective.
Do not shave the pet’s neck as this
may increase the risk of skin irritation.
4. Check the tightness of the Receiver Collar by
inserting one finger between the collar and
your dog’s neck ( 3C ). The fit should be snug
but not constricting.
5. Allow your dog to wear the Receiver Collar for
several minutes then recheck the fit. Check the fit again as your dog becomes more comfortable
with the Receiver Collar.
3A
3B
3C