Changing the dust bag, Cleaning the motor filter, Cleaning the exhaust filter (25) – Инструкция по эксплуатации LG V-C3G42ND
Страница 6: What to do if your appliance does not work, What to do when the suction performance reduces
Внимание! Текст в этом документе был распознан автоматически. Для просмотра оригинальной страницы Вы можете воспользоваться режимом "Оригинал".
I
Changing the dust bag
The dustbag needs changing when the cleaner
is set to maximum power and the cleaner head
is off the floor but the “bag full” indicator
window(18) is completely coloured red.
Even If the dustbag does not appear to be
full at this stage, It should be changed.
It could be that a great deal of very fine dust
has clogged up the pores of the dust bag.
• Turn off the appliance and unplug it.
• Open the cover by pressing the hook(19)
and lifting It up until it snaps Into place.
Your appliance Is equipped with either a
paper dust bag (20) or a fabric dust bag
(22)(depending on model).
■ Take hold of the dust bag by the handle
and pull.Remove the bag and throw It
away.
• To refit a new bag push the cardboard
support of a new bag into the bag mount
(21)until it will go no further.
If your appliance is fitted with a fab
ric dust bag
follow the same Instructions
as above.
Empty It and replace lt(22).
Note: as the appliance Is fitted with a safety
device which checks that the bag Is In place
you cannot close the lid If the bag Is not
fitted correctly.
Cleaning the motor filter
The
motor
filter
Is
situated
Inside
the
appliance between the filter supporter (23)
and the motor. Each time that you change
the air outlet filter we advise you to pull the
handle on the filter supporter, remove the
motor filter (24) and to clean It by tapping
to remover the dirt and then replacing it in
the vacuum cleaner.
Cleaning the exhaust filter (25)
* Check the exhaust filter occasion-ally and
clean when dirty.
* Unplug cord from outlet.
* Open the exhaust cover (26) and remove
exhaust filter as shown.
* Next procedures are the same as the
moter safety filter.
* Turbine brush nozzle (27).
'Easy & Powerful cleaning through
adjusting the air-control lever (28).
^ : use for hard floor & short
type carpet.
roflOOflOOfl
: use for long type carpet.
' Cleaning turbine brush nozzle (29)
Press the button on the rear side of the
nozzle to separate the air cover.
Use the dusting brush & crevice tool to
vacuum clean the brush and fan.
What to do if your appliance
does not work?
Check that the appliance Is correctly plugged
In and that the electrical socket Is working.
What to do when the suction
performance reduces?
' Stop the appliance and unplug it.
' Check that the tubes, flexible hose and
cleaning tool are not blocked.
' Check that the dust bag Is not full.Replace
if necessary.
-5-