Vitek VT-1913 - Инструкция (Страница 4)

5
0 STOP
1 LOW SPEED
2 MEDIUM SPEED
3 HIGHSPEED
To switch the fan on, simply press one of the push buttons (1. 2 or 3). To stop it, press the 0
push button.
OSCILLATION
Simply press down on the button located vertically at the rear of the motor. To stop the oscil
lation action, pull the button back up to its initial position.
SETTING THE TILT ANGLE
Slack off the knurled screw on the ball joint, move the fan to the desired angle, then tighten
the knurled screw down again.
MAINTENANCE
1. Always unplug the fan before performing any maintenance work.
2. Carefully clean the fan prior to storing.
3. When storing the fan during the winter months, be sure to keep it in a dry location protect
ed from damp.
4. While using the fan, be sure to keep it clean by periodically wiping it with a cloth soaked in
soapy water.
5. Never use detergents or solvents.
6. Always follow the assembly procedure with care when re assembling the fan.
SPECIFICATION
Power
50 W
Voltage 220 230 V ~ 50 Hz
Blade diameter 16” (40 cm.)
3 speed control
SERVICE LIFE OF THE FAN NOT LESS THAN 5 YEARS
4
ENGLISH
СХЕМА ВЕНТИЛЯТОРА
РУССКИЙ
1913.qxd 03.12.03 14:53 Page 8