Vitek VT-1910 - Инструкция (Страница 3)

WARNINGS
1. Before connecting the appliance, check that the power supply at home corresponds to
the voltage indicated on the appliance.
2. Do not immerse the appliance in any liquid and do not use it near showers or baths.
3. Do not touch the appliance with wet or dumphands.
4. Do not use extensions on bathroom or shower, unless with particular care.
5. Do not leave the appliance within reach of children or irresponsible persons without
supervision.
6. Before carrying out any cleaning operation always disconnect the appliance form the
mains power supply, by removing the plug or switching it off.
7. Beware tot the cable is not damaged.
8. Do not pull the supply cable or the appliance to remove the plug from the socket.
9. The users should not replace the supply cable and/or the plug or this appliance. In case
of damage, or for the replacement apply only to a specialized technician.
10. The appliance is not intended for use by young children or infirm persons without super
vision.
11. Young children should be supervised to ensure that they do not play with the appliance.
NOTE: IF THE ORIGINAL STRUCTURE RENEWS, PLEASE EXCUSE NOT TO BE INFORMED.
PLEASE REFER TO REAL PRODUCT.
HOW TO ASSEMBLE:
BEFORE INSTALLMENT, PLEASE CHECK:
1. AFTER OPEN THE WRAPPING, PLEASE CHECK THE QUANTITY OF THE PARTS TO SEE IF
THE PARTS ARE COMPLETE.
2. PLEASE MAKE CLEAR THAT THE WORKING VOLTAGE AT YOUR LOCAL AREA IS FOLLOW
ING THE VOLTAGE RANGE PRINTED ON OUR RATING LABEL.
3. PLEASE CHECK IF THE FAN HEAD MOVE FREELY.
INSTALLATION:
1. INSERT THE BASE SUPPORTING POLE INTO BASE PLATE AND FASTEN WITH 6 PCS OF
M4*10 SCREWS.
2. INSERT THE MAIN BODY INTO THE BASE SUPPORTING POLE AND FASTEN FROM THE
BACK OF MAIN BODY WITH 2 PCS OF M4*10 SCREWS.
3. LOOSEN THE REAR GUARD NUT FROM THE FRONT MOTOR HOUSING,THEN PUT ON
THE REAL GUARD AND FASTEN THE REAL GUARD NUT. PUT ON THE FAN BLADE
THROUGH THE MOTOR AXIS AND FASTEN ANTICLOCKWISE BY BLADE NUT.
4. FIX THE FRONT GUARD AT THE SAME LEVEL OF THE REAR GUARD, AND INSTALL THE
GUARD RING AND FASTEN BY THE GUARD RING SCREW.
HOW TO USE THE STAND FAN:
1. PITCHING ANGLE ADJUSTMENT:
MANUALLY CHANGE THE PITCH ANGLE TO UPWARD SIDE OR DOWNWARD SIDE, THE
PITCHING ANGLE WILL BE AUTO LOCKED AT ONCE BY THE LITTLE SPRING BALL LAID
INSIDE THE SUPPORTING PART.
2. HEIGHT ADJUSTMENT:
RELEASE THE SUPPORTING POLE NUT WHEN THE HEIGHT MEETS YOUR REQUIREMENT
AND FASTEN THE NUT.
3
ENGLISH
10
VT-1910.qxd 11.12.02 12:03 Page 6