Kastor KS Wood-burning sauna stoves - Инструкция (Страница 27)

27 / 57
1. Before you install
Inspect both product and the contents of the package as soon as you receive them. Report any
transport damages to the deliverer.
1.1. Package contents and its inspection
The stove package contains:
•
Stove
•
Within the fire compartment
o
Installation instructions
o
Grate
o
Air guide plate
o
Connection pipe
o
2 adjustment legs
o
Door handle, Attachment screws and washers
•
Two steel caps (one on the foremost sweeping hole and another on the back wall flue
hole, which bolted into place with a screw driven through the intermediate mantle).
1.2. Important matters and regulations
During installation and use these instructions and all relevant official regulations must be
followed. The sauna stove must not be used for any other purposes such as drying clothes,
heavy heating during building etc. The stove must also never be covered in any way during use
or when it is warm.
Also check the following aspects and their influence on your choice of stove installation location:
o
Safety distances to flammable and non-flammable structures (Chapter 2.3. and
2.4.)
o
Location of chimney connection (height from floor of any existing chimney
connection or installation route of any new chimney pipe)
o
Floor material (flammable, non-flammable, tiled and waterproofed)
2. Installation and preparation for use
2.1. Preparing for use and burn-in
•
Install door handle according to chapter 2.7.
•
Place the stove outdoors on a non-flammable surface
o
without stones
o
tank, if any, filled with water
•
Remove any decals and protective plastic sheeting.
•
Check that the grate and air guide plate (see chapter 2.8.) are in place.
•
Install the connection pipe delivered with the package into the backmost flue opening on
top of the sauna stove or the hole in the back wall. In JK models it goes into the hole
nearest the wall on top of the stove.
•
The caps delivered with the stove are required to close the other holes. The hole in the
back wall must also be capped.
•
Burn-in: The purpose of the burn-in is to remove out of doors any flammable protective
coating substances and to harden the stove’s coating. Burn a few full loads of wood in the
fire compartment. Continue the burn-in until there are no more fumes rising from the
stove.
•
Once the stove has cooled down after the burn-in, move it into the sauna.
•
See to it that the sauna is well ventilated during the first couple of heating.