Sven Stream - Инструкция (Страница 10)

USER’S MANUAL
10
5. THE SYSTEM CONNECTION INSTRuCTION
WARNING! All components should be switched off before connection.
5.1. connection to the sound source
While connecting to the sound source, use the RCA pin type connecting line.
Please connect correctly the marked «left» jack to other marked «left» plug of other components.
5.2. loudspeakers connection
don't shortcircuit acoustics cable ends.
6. SYSTEM INSTALLATION AND OPERATION
first make sure that all connections are correct and then switch on the speaker system.
• Plug the connector for power.
• Revolve regulator knobs to the minimum; press the power button on the backside of the active loudspeaker.
• Adjust the BASS knob to set bass effect.
• Adjust the TReBLe knob to set high-frequency level.
• Adjust the VoLuMe knob to set general system volume level.
• use the soundcard Line-out port to improve sound quality.
7. TROuBLE CHECKING AND SHOOTING
Problem cause Solution
no power The power plug is connected improperly Reconnect properly
The power switch is not turned on Turn on the power switch
no sound The volume regulator is at minimum position Turn the volume regulator properly
The signal source is connected improperly Connect properly
no woofer sound
or volume low The signal source improper connection Connect the signal source properly
The woofer volume regulator is at minimum position Adjust the woofer regulator properly
distortion Volume is too loud Adjust the volume regulator properly