Vitek VT-4024 - Инструкция (Страница 11)

TROUBLE SHOOTING
If the system do not operate correctly, please do the following check up
Some DVD device has high level signal output, when the Master Volume is at the maximum the distor-
tion occurs, if this happens, turn down the volume, if the speaker continues in the distortion, the speak-
er unit and amplifier will be damaged.
SPECIFICATION
OUTPUT POWER
SUBWOOFER
60 W
FRONT AND REAR 20 W x4
CENTER 20 W
MAXIMUM OUTPUT POWER 160 W
SPEAKER UNIT
WOOFER
6-1/2
FRONT 3 (Full Range)
REAR 3 (Full Range)
CENTER 3 (Full Range)
DIMENSION
SUBWOOFER
6-1/2 6,5” (16,5 cm)
FRONT 3” (Full Range) (7,6 cm)
CENTER 2x3“ (Full Range) (2x7,6 cm)
ACCESSORIES
AAA BATTERIES
2 PCS
SPEAKER CABLES 3 PCS 2 m (CENTER&FRONT)
2 PCS 6 m (REAR)
IN ORDER TO DELIVER THE BEST QUALITY, THE SPECIFICATION OF THE SPEAKER MIGHT
CHANGE WITHOUT SUBJECT OF NOTICE
SERVICE LIFE OF THE UNIT NOT LESS 7 YEARS
10
ENGLISH
ISSUE CAUSED BY SOLUTION
No Sound from Speaker
No sound from speaker
when chose DVD/5.1 out-
put mode
Distortion occurred when
in high volume
1. System does not con-
nected with power.
2. The speaker cables are
not connected with the
output connector
3. The power does not
switch ON.
The output setting of the
DVD might set to dts
decode mode
The sound device has nigh
level signal output
1. Check with the power
plug
2. Check the speaker
cables
3. Make sure the power is
ON
Reset the output setting
to 5.1 CH output only
Turn down the master vol-
ume of the system
4024.qxd 27.08.2004 16:39 Page 10