Vitek VT-1122 - Инструкция (Страница 3)

! INSTRUCTION FOR USE OF THIS APPLIANCE
• Before using for the first time, boil the kettle twice with clear water to make
sure that it is completely clean. Pour away all the boiled water and refill.
• Kettle can be filled either through the spout or open the lid. Then fill water.
• Water level can be estimated through the window gauges at both sides on
body.
• After filling your kettle with water, place the kettle to the power base unit,
ensure the kettle completely sits on the connector. Plug in and switch on the
wall socket. Switch on the kettle by pressing down the switch button.
• Do not overfill the kettle over the Max. level. However the minimum amount
of water should reach the Min. marking.
• When the water boils, kettle will be automatically switch off .
• To re boil the water, switch on again by just pressing down the switch button
once again. If the kettle has just switch off automatically, waiting for a minute
before switching it.
• If the kettle do not fill with enough water or it is empty; switch on the kettle will
cause the safety cutout switch off the power automatically. If this happens,
set the switch level to OFF position and wait for a few minutes for the appli
ance to cool down, then refill with enough water and switch on as normal.
• Before removes the kettle from power stand, ensure that the kettle is
switched off.
• Power cord could be stand into the power base by just push the cord inside
the base.
! FILTER
• If appliance installed with the filter always fill
the appliance through the spout, as this will
help to restrict any major impurities & lime
scale.
• To remove the filter, open the lid and empty
the appliance. Push the filter outward the tab.
• Re install the filter, slide it into the tag and
press down, it will snap on the tag firmly.
Ensure the filter is properly fit into the spout
location.
ENGLISH
3 10
1122.qxd 30.04.03 13:48 Page 6