Инструкция по эксплуатации Vitek VT-1223
Страница 10
10
11
1.
Ручка утюга
2.
Кнопка подачи струи пара
3.
Кнопка увлажнения
4.
Регулятор различных
режимов отпаривания
/самоочистки
5.
Отверстие для заполнения
водой
6.
Распылитель
7.
Защита сетевого шнура
8.
Терморегулятор
9.
Подошва утюга
ОПИСАНИЕ ЧАСТЕЙ УТЮГА
РУССКИЙ
DRAINING THE WATER
1. Move the Steam Control/Self Cleaning Knob to position.
2. Disconnect the iron from the mains supply outlet.
3. Press the Burst Of Steam button to release any trapped water when
the sole plate still hot.
4. Press the Spray Buttons to release any trapped water.
5. Hold the iron upside down and gently shake it to remove the
remaing water.
Note: Set the Steam Control Knob to position before storing the
iron.
CLEANING THE IRON
1. Disconnect the iron from the mains supply outlet.
2. Use a damped cloth or non scratching cleaner to remove any
deposits on the sole plate or the cabinets.
Note:
Never use sharp or rough objects to remove the deposits on the sole
plate.
Never use any abrasive, vinegar or descaling agents to clean the iron.
SPECIFICATION
Power requirement
230 V ~ 50 Hz
Max. power
2020 W
SERVICE LIFE OF THE IRON NOT LESS THAN 3 YEARS
ENGLISH
1223.qxd 13.01.04 15:22 Page 18