Инструкция по эксплуатации Vitek VT-1203
Страница 4
17
HINTS FOR IRONING
1. Sort out the articles to be ironed according to the type of fabric.
This will minimize the frequency of temperature adjustment for dif
ferent garments.
2. Test ironing a small area on the backside or inside the garment if
you are unsure about the type of fabric. Start with a low tempera
ture and increase gradually.
3. Wait for about three minutes before ironing heat sensitive fabrics.
Temperature adjustment needs certain time to reach the required
level no matter it is higher or lower.
4. Delicate fabrics such as silk, wool, velour, etc. are best ironed with
an ironing cloth to prevent shine marks.
5. You may need a few times of press to activate the spray, burst and
vertically burst function.
HOW TO FILL WATER
1. Disconnect the iron from mains supply
outlet.
2. Move the Steam Control/Self Cleaning
Knob to
position.
3. Fill water through the water inlet hole.
(See figure 2)
4. Fill up to the 'Max' level marked on the
side of water tank.
Note: For best result, it is advisable to use demineralised water or dis
tilled water.
Do not use chemically descaled water or any other liquids.
FIRST TIME IRONING
1. Remove any protective films or stickers from the sole plate and the
cabinet.
2. Unwind and straighten the power cord.
3. Fill the water tank with demineralised water or distilled water. (See
How To Fill Water)
4. Connect the iron to a suitable mains supply outlet.
4
FIGURE 2
На ярлыке означает: изделие нельзя гладить!
(например, эластик)
Примечание:
вид ткани
синтетика
синтетика
ацетатволокно
триацетат
с люрексом
полиамид
(нейлон)
полиэстер
вискоза
шелк
шерсть
шерсть
хлопок
хлопок
лен
лен
синтетика
акрил
полипропилен
полиэтан
волокно
позиция
терморегулятора
ярлык
шелк
ENGLISH
РУССКИЙ
1203.qxd 03.07.03 16:47 Page 8