Bp u, Energy-saving cooling mode (optional), Forced operation – Инструкция по эксплуатации LG MC07AHV
Страница 13: Display luminosity (optional), Test operation
Owner's Manual 13
ENGLISH
Energy-Saving Cooling Mode (Optional)
Operating Instructions
The Display Luminosity can be adjusted by using the remote control.
Open the door of the remote controller, and press the LCD LUMINOSITY button.
Display will be dark. Press the button again to set bright display.
Forced operation
Operation procedures when the remote control can't be used. The operation will be started if the ON/OFF button
is pressed. If you want to stop operation, re-press the button.
Energy-saving cooling mode can save energy in cooling and healthy dehumidification operation, because it
can operate efficiently by setting body-adaptation time according to the change of time and temperature and
adjusting automatically desired temperature.
1. Press the ON/OFF BUTTON to start the unit.
2. Open the door of the remote controller. Select cooling
operation or healthy dehumidification operation.
3. Press the ENERGY-SAVING COOLING MODE BUTTON.
4. To cancel the energy-saving cooling mode, press the ENERGY-SAV-
ING COOLING MODE BUTTON again and unit will operate in previous
mode(Cooling or healty dehumidification mode).
Heat pump Model
Cooling Model
Room Temp. ≥ 24°C
21°C ≤ Room Temp. < 24°C
Room Temp. < 21°C
Operating mode
Cooling
Cooling
Healthy Dehumidification
Heating
Indoor FAN Speed
High
High
High
High
Setting Temperature
22°C
22°C
23°C
24°C
Test operation
During the TEST OPERATION, the unit operates in cooling mode at high speed fan, regardless of room temperature
and resets in 18 minutes.
During test operation, if remote controller signal is received, the unit operates as remote controller sets.
If you want to use this operation, Press and hold the ON/OFF button for 3~5 seconds, then the buzzer sound 1 "beep".
If you want to stop the operation, re-press the button.
Display Luminosity (Optional)
ON/OFF
button
Power
Power
button
button
Power
button
Because Energy-Saving Cooling Mode is optional function, some product will not operate.
Because Display Luminosity is optional function, some product will not operate.
b
P u