Safety instructions – Инструкция по эксплуатации Electrolux EWC1150

Страница 3

Advertising
background image

• Obey the maximum load volume of 3 kg (refer to the “Pro-

gramme chart” chapter).

• If the supply cord is damaged, it must be replaced by the

manufacturer, its service agent or similarly qualified persons
in order to avoid a hazard.

• The operating water pressure (minimum and maximum)

must be between 0,5 bar (0,05 MPa) and 8 bar (0,8 MPa)

• The ventilation openings in the base (if applicable) must not

be obstructed by a carpet.

• The appliance is to be connected to the water mains using

the new supplied hose-sets. Old hose sets must not be
reused.

SAFETY

INSTRUCTIONS

INSTALLATION
• Remove all the packaging and the transit

bolts.

• Keep the transit bolts. When you move

the appliance again you must block the
drum.

• Do not install or use a damaged appli-

ance.

• Do not install or use the appliance where

the temperature is less than 0 °C or
where it is exposed to the weather.

• Obey the installation instruction supplied

with the appliance.

• Make sure that the floor where you install

the appliance is flat, stable, heat resistant
and clean.

• Do not install the appliance where the ap-

pliance door can not be fully opened.

• Always be careful when you move the

appliance because it is heavy. Always
wear safety gloves.

• Make sure that there is air circulation be-

tween the appliance and the floor.

• Adjust the feet to have the necessary

space between the appliance and the
carpet.

Electrical connection

Warning! Risk of fire and electrical
shock.

• The appliance must be earthed.
• Make sure that the electrical information

on the rating plate agrees with the power
supply. If not, contact an electrician.

• Always use a correctly installed shock-

proof socket.

• Do not use multi-plug adapters and ex-

tension cables.

• Make sure not to cause damage to the

mains plug and to the mains cable. Con-
tact the Service or an electrician to
change a damaged mains cable.

• Connect the mains plug to the mains

socket only at the end of the installation.
Make sure that there is access to the
mains plug after the installation.

• Do not pull the mains cable to disconnect

the appliance. Always pull the mains
plug.

• Do not touch the mains cable or the

mains plug with wet hands.

• This appliance complies with the E.E.C.

Directives.

Water connection
• Make sure not to cause damage to the

water hoses.

• The appliance is to be connected to the

water mains using the new supplied
hose-sets. Old hose sets must not be
reused.

electrolux 3

Advertising