Vitek VT-3490 - Инструкция (Страница 10)

3. Press NEXT or BACK to choose desired track.
4. When chosen track number appears on the LCD press MEMORY button
once to store the track.
5. Repeat steps 2 to 4 to select and store all desired tracks into memory.
6. After end of programming press PLAY button to start programmed playback.
MP3 PROGRAMMED PLAYBACK
The MP3 player unit has a 64 track programmable memory capacity
which allows to program up to 64 tracks on any disc for playback in any
desired order. To program tracks for playback the player must be in the
stop mode. If the disc is playing, press the STOP button to stop playback
and then proceed as follows:
1. Make sure player is in stop mode
2. Press MEMORY button once, album number digits will be flashing.
3. Press NEXT or BACK buttons to select desired album.
4. Press MEMORY button once, track number digits will be flashing.
5. Press NEXT OR BACK to select desired track, press MEMORY once to store selected track.
6. Repeat steps 2 to 5 to select and store all desired tracks into memory.
7. After end of programming press PLAY button to start programmed playback.
Reviewing created program
In STOP mode, press MEMORY the display your stored track numbers in sequence.
Program play
Press PLAY button to playback created program.
Erasing created program
You can erase created program:
- Open the CD lid
- Press FUNC or BAND button
RANDOM PLAY
-Press RANDOM button on the remote control, "RANDOM" sign will appear on the LCD.
-Press RANDOM button twice to resume normal playback.
INTRO PLAY
-Press INTRO button on the remote control, "INTRO" sign will appear on the LCD.
-Press INTRO button twice to resume normal playback.
CARE AND MAINTENANCE
SAFEGUARD AGAINST ACCIDENTAL TAPE ERASE
• When a new recording is being done, any program material previously recorded will be automatically
erased and only new recording will remain. To safeguard valuable recordings from being erased
accidentally, cassette and the deck mechanism are equipped with a spacial device.
• On the back of cassette there is an erase prevention tab on each side. To prevent
accidental erasing, break out these tabs wish a small screwdriver. If only one side of the tape is to
be protected, break out the tab on the left side with the side to be protected facing you.
• To record on a tape in which the tab has been broken, place a piece of adhesive tape over that area.
NOTE: When a tab is broken out, the RECORD key cannot be depressed.
ENGLISH
9
3490.qxd 24.01.2005 18:27 Page 9