Binatone DVC-7180 - Инструкция (Страница 6)

6
BEFORE USE
Vacuum cleaner assembly
Dust bag installing
Check if the dust bag is in place: press the knob
(5) for opening of the dust bag compartment.
Install the paper bag (13) or the cloth bag
(14) (ref. to «Cleaning and Maintenance» sections).
Flexible hose connection
Insert plastic base of the flexible hose (3) in the inlet hole (2).
Turn the hose (3) right when it is pushed into the bottom, a click of
inserting sound may be heard.
Flexible hose disconnection
Rotate the hose contra clockwise and pull out it.
Application of nozzles and working parts
! By pressing the tube length control button, pull-out the tele-
scopic tube (7) as required. The tube length could very in the
range of 49-79 cm.
! Insert the flexible hose (3) in the telescopic tube (7).
! Put the required nozzle on the telescopic tube:
Multipurpose nozzle «Floor/Carpet» (19):
You can change the operating mode of the nozzle: with an
extended brush – for cleaning carpets, and without the brush –
for flat surfaces.
High-efficiency turbo-brush (22) is designed for conve-
nient and fast collecting of house moss and animal-hair.
Nozzles for narrow spaces and furniture (20,21)
You may use a crevice nozzle for cleaning hard-to-reach
places, and a special brush for cleaning upholstery.
The nozzles for narrow spaces and furniture (20,21) can be
stuck in the corresponding clips on the accessory bracket (23).
OPERATING INSTRUCTION
Using the appliance
1. Before using the appliance, select the re-
quired length of the power cord: yellow mark
at the power cord indicates the optimum
length of the power cord, whilst the red mark
indicates the maximum length.
Attention: Red mark is the limiter of the power cord
maximum length.
2. Connect the appliance to the power grid whose voltage shall
correspond to the voltage rating indicated on the appliance.
Use only grounded sockets.
3. Press «ON/OFF» (9) to switch on the vacuum cleaner. Press
«ON/OFF» (9) once again to switch off the vacuum cleaner.
4. There is the vacuum cleaner power mode selector at the vacuum
cleaner casing (11). Using the power mode selector, you can