Vitek VT-1764 - Инструкция (Страница 4)

4
ENGLISH
• Do not cover the ventilation openings
and avoid foreign objects getting inside
them
.
• Do not immerse the unit into water or
other liquids.
• Do not move or tilt the unit during its op-
eration
.
• Always unplug the unit and pour out the
water from the water tank when clean-
ing the unit or when you do not use it.
Unplug the unit before moving it to an-
other place.
• Do not touch the power plug with wet
hands.
• Before using the unit, closely examine
the power cord and make sure that it is
not damaged. Do not use the unit, if its
power cord is damaged.
• Do not disassemble the unit yourself,
if any malfunction is detected, apply to
the nearest authorized service center.
• Regularly clean the unit; be careful not
to make any scratches on the sprayer.
• Store the unit out of reach of children.
FOR HOUSEHOLD USAGE ONLY
USING THE HUMIDIFIER
Unpack the unit and remove the packing
materials. Examine the unit for damages.
Do not switch on the unit if there are any
damages in it.
Note:
- if the unit was subjected to negative
temperatures, before switching it
on for the first time, keep it at room
temperature for 30 minutes.
- use the unit at temperatures from +5
to +40°С, and relative humidity less
than 80%.
- water temperature should not ex-
ceed +40°С.
Before switching on the unit, make sure
that you home electricity supply corre-
sponds to the voltage specified on the
body of the unit.
1. Take the handle (10) and remove the
water tank (11) from the body (17).
2. Turn over the tank (11); unscrew the lid
(15), by turning it anti clockwise. Fill the
water tank (11) with necessary quantity
of water and screw the lid on (15), by
turning it clockwise.
3. Set the filled tank (11) on the body of
the unit (17). Wait for some time, which
is necessary to fill the operating cham-
ber with water.
4. Plug in the humidifier, the indication
(21) will appear on the display (7); the
room temperature (27) and humidity
(28) will be displayed.
5. Switch on the humidifier, by pressing
the (5) “Power” on/off button, the in-
dication (21) will go out, the display will
switch to full brightness and the steam
intensity indication (26) will light up.
Note:
- each pressing of the control buttons
will be accompanied with a sound
signal.
- if no button has been pressed dur-
ing 30 seconds on the control panel
or on the remote control, the display
brightness will decrease automati-
cally.
6. To switch on the ionization mode, press
the (6) “Ozone” button, the indication
(25) will appear on the display (7). To
switch off the ionization mode, press
the (6) “Ozone” button once again, the
indication (25) will disappear.
7. To switch on the heating mode, press
the (1) “Heating” button, the indication
(22) will appear on the display (7). In
this mode the evaporated water will be
4
1764.indd 4 1764.indd 4 04.06.2010 14:11:17 04.06.2010 14:11:17