Instructions for use, Maintenance and cleaning – Инструкция по эксплуатации Binatone TWT-910
Страница 6
6
INSTRUCTIONS FOR USE
1. Place your waffle maker upon a dry, smooth
and plain horizontal surface.
2. Set cooking temperature to the lowest level
by turning the temperature control selector
(7) to OFF position. You can choose a proper
temperature for your waffle and get higher
temperature by turning the control knob
counterclockwise.
3. Then plug cord into an electrical outlet, the operation indicator
light (4) will turn on.
4. Always preheat the appliance for 5 minutes before baking.
When the unit has reached the proper temperature, the tem-
perature indicator light (5) will turn on.
5. When appliance is ready, open it and oil the panels (6) with
margarine or other cooking fat.
6. Turn some dough onto the lower baking plate with 2-3 cm
edge distance.
Attention:
Do not fill too much dough. The appliance can’t
be locked.
7. Carefully lower the appliance lid pushing it lightly, and fix the
latch (3).
8. Your waffle will be ready in 2-3 minutes. Open your waffle
maker and gently take the waffle off using a wooden (or heat-
resisting plastic) spatula.
Attention:
To avoid damaging the non-stick coating, never use
metallic objects (fork, knife) or any other sharp objects.
9. Use the cone maker (8) to roll over the waffle to create the
cone shape. Let it cool down for a bit before removing from the
cone, so it can keep the cone shape.
10.If your waffle is not brown enough, change cooking tempera-
ture with the temperature control selector (7). Watch the
appliance closely to avoid waffle burning.
11.To switch the waffle maker off just unplug it.
Warning:
After use, always unplug the appliance.
MAINTENANCE
AND CLEANING
1. Always unplug and let your appliance cool
down before cleaning.
2. Wipe the waffle maker case (1) with wet
cloth. Do not use the appliance until it dries
out completely. Do not use abrasive materi-
als, alcohol, gasoline, etc., to clean the ap-
pliance.
3. Wipe the non-stick panels (6) with soft, slightly wet cloth or
sponge. Do not clean panels with hard materials (metallic sponge,
abrasive materials, etc.) or you will damage the surface.