English, Turbo steam, Burst of steam in a vertical position – Инструкция по эксплуатации Binatone SI-4060
Страница 7: Spray, Auto stop, Ionized steaming function
ENGLISH
7
to the required temperature level then put the control knob (9)
into the required position.
Attention:
Application of the steam ironing function is
impossible at «•» temperature setting. SI-4060 iron:
the «Drip Stop» system automatically terminates the
steam generation process if the selected temperature is
too low. When the system is activated, you may hear
a click.
Turbo steam
To ease ironing of dense cotton, linen and upholstery articles
use the steam burst button (8): engagement of the button (8)
during the ironing process generates an extra burst of steam from
the sole plate to help remove stubborn creases.
Burst of steam in a vertical position
This function helps to freshen the appearance of curtains, jack-
ets, coats, etc. To use this function, take the following steps:
! Follow instructions in paragraph 1-4 of the section «Operation
instructions». While selecting the temperature setting, put the
temperature control knob (10) into the «Max» position.
! While holding the iron in a vertical position, aim its sole plate
towards the articles to be ironed and push the steam burst
button (8) to produce a directional strong burst of steam from
the sole plate. Push the button several times with 5-7 seconds
intervals until the article is fully refreshed. If during the process
your water tank (5) runs out of water, disconnect the appliance
from the mains outlet, wait till it cools down, refill the tank and
plug the appliance back into the power supply and continue the
process.
Spray
Using the water spray (7) will help when ironing details of the
article (cuffs, trimmings, plackets, etc) or clothes, which demand
«•» (low temperature) ironing, when steam ironing is not possible.
Push the button several times to moisten the material.
Auto stop
For safety reasons, your iron will automatically stop heating if
it’s left:
! upright for 8-15 minutes, or
! flat for 10-30 seconds.
The Operation indicator (11) will flash. The iron will heat up
again when you move it and the operation light will go out.
! To deactivate automatic shut off, stand iron on heel or shake
gently, then the iron will switch on again.
Ionized steaming function
In the dry ironing and steam ironing of process can be used
the ionized steaming function.