Acme WB01 - Инструкция (Страница 6)

For example:
In the PC platform, program Brake function of the Left Pedal into the
button 5.
1) Press BUTTON 9 for 3 seconds, the LED will fl ash three kinds of color.
2) Press Left Pedal button, LED will fl are blue and green lighting, and then
press the button 5 you would like to assign.
3) After above, the LED will fl ash three kinds of color lighting at the same
time, it shows that buttons were programmed successfully.
4) Go to your next programming.
5) Press BUTTON 9 to exit programing mode.
3. To Exit programming:
1) During programming, when LED fl ashing, do not touch any button, 6
seconds later, the programming function exits automatically.
2) Press BUTTON 9 one time, this will exit programming mode.
Note: Do not program any button during gaming, or it will infl uence the operation.
Reset:
Press MODE button for 3 seconds, then relax it, after that wheel returns to the
default function and sensitivity.
2. Hot plug for pedals
Product can support pedals hot plug. When pedals are not connected with
the wheel, left and right hand levers perform the same functions as the Brake
and Acceleration pedals.
Connect pedals and wheel, they will keep the default function again.
3. Vibration function state
1. The wheel has default vibration function. Press BUTTON 9 + UP (on D-pad)
for one second, the LED will fl ash three kinds of color lighting at the same
time. It shows the vibration function is turned off .
2. Press BUTTON 9 + UP (on D-pad) for one second again to turn on vibration
function.
EN