WORX Tools WU307.1 - Инструкция (Страница 9)

Hammer Drill ENG
instructions to operate the power tool.
Power tools are dangerous in the hands of
untrained users.
e) Maintain power tools. Check for
misalignment or binding of moving
parts, breakage of parts and any other
condition that may affect the power
tools operation. If damaged, have the
power tool repaired before use. Many
accidents are caused by poorly maintained
power tools.
f) Keep cutting tools sharp and clean.
Properly maintained cutting tools with sharp
cutting edges are less likely to bind and are
easier to control.
g) Use the power tool, accessories and
tool bits etc., in accordance with
these instructions and in the manner
intended for the particular type of
power tool, taking into account the
working conditions and the work to
be performed. Use of the power tool for
operations different from intended could
result in a hazardous situation.
5. SERVICE
a) Have your power tool serviced by
a qualified repairperson using only
genuine replacement parts. This will
ensure that the safety of the power tool is
maintained.
6. SPECIFIC SAFETY RULES
a) Always wear safety glasses or eye
shields when using the drill. Everyday
eyeglasses have only impact-resistant
lenses; they are NOT safety glasses.
Following this rule will reduce the risk of
serious personal injury.
b) Always wear a face mask or dust mask.
Following this rule will reduce the risk
of serious personal injury.
c) Always wear hearing protection
during extended periods of operation.
Following this rule will reduce the risk of
serious personal injury.
d) Hold tool by insulated gripping
surfaces when performing an operation
where the cutting tool may contact
hidden wiring or its own cord. Contact
with a “live” wire will make the exposed
metal parts of the tool “live” and shock the
operator.
e) Do not use dull . Bent blades can break
easily, or cause kickback.
ADDITIONAL SAFETY
POINTS FOR YOUR DRILL
1. Remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
2. Fully unwind cable drum extensions to avoid
potential overheating.
3. When an extension cable is required you
must ensure it has the correct ampere rating
for your power tool and that it is in a safe
electrical condition.
4. Ensure your mains supply voltage is the
same as your tool rating plate voltage.
5. Your tool is double insulated for additional
protection against a possible electrical
insulation failure within the tool.
6. Always check walls and ceilings to avoid
hidden power cables and pipes.
7. After long working periods, external metal
parts and accessories could be hot.
SYMBOLS
09 08
Read the manual
Warning
Wear eye protection
Double insulation
Wear ear protection
Wear dust mask
RUS-WU305.1 WU307.1-M-060726.indd 9 2006-7-26 13:46:25