Router eng, Specific safety rules, Additional safety rules for your router – Инструкция по эксплуатации WORX Tools WU601.1
Страница 9
Router ENG
untrained users.
e) Maintain power tools. Check for
misalignment or binding of moving
parts, breakage of parts and any other
condition that may affect the power
tools operation. If damaged, have the
power tool repaired before use. Many
accidents are caused by poorly maintained
power tools.
f) Keep cutting tools sharp and clean.
Properly maintained cutting tools with sharp
cutting edges are less likely to bind and are
easier to control.
g) Use the power tool, accessories and
tool bits etc., in accordance with
these instructions and in the manner
intended for the particular type of
power tool, taking into account the
working conditions and the work to
be performed. Use of the power tool for
operations different from intended could
result in a hazardous situation.
5. SERVICE
a) Have your power tool serviced by
a qualified repair person using only
identical replacement parts. This will
ensure that the safety of the power tool is
maintained.
SPECIFIC SAFETY RULES
WARNING: Some dust particles
created by power sanding, sawing,
grinding, drill and other construction jobs
contain chemicals known to cause cancer,
birth defects or other reproductive harm.
Some examples of these chemicals are:
Lead from lead-based paints.
Crystalline silica from bricks and cement and
other masonry products.
Arsenic and chromium from chemically
treated lumber.
Your risk from these exposures varies,
depening upon how often you do this type
of work.
To reduce your exposure to these
chemicals:
Work in a well-ventilated area.
Work with approved safety equipment, such
as those dust masks that are specially
dsigned to filter microscopic particles.
ADDITIONAL SAFETY
RULES FOR YOUR
ROUTER
1. Always wear a dust mask.
2. Wear protective glasses and hearing
protection.
3. For long hair, wear hair protection. Work
only with closely fitting clothes.
4. If the mains cable is damaged or cut through
while working, do not touch the cable. Never
use the machine with a damaged cable.
5. Do not operate the machine in rain or or
high moisture conditions.
6. Always direct the cable to the rear away
from the machine.
7. Contact with electric lines can lead to fire
and electric shock. Damaging a gas line can
lead to explosion. Penetrating a water line
causes property damage or may cause an
electric shock.
8. Contact with a “live” wire will make exposed
metal parts of the tool “live” and shock the
operator.
9. When working with the machine, always
hold it firmly with both hands.
10. Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held
more secure than by hand.
11. Before putting into operation, check the
routing tool for firm seating.
12. Never route over metal objects such as nails
or screws.
13. Keep hands away from rotating router bits.
14. After finishing work, guide the machine back
into the upper starting position by actuating
the clamping lever and switch the machine
off.
15. Always switch the machine off and wait until
it has come to a standstill before placing it
down.
16. Protect tools from impact and shock.
17. Never allow children to use the machine.
09
08
UKR-WU600 WU600.1 WU601 WU601.1-M-060726.indd 9
2006-7-26 14:08:52