WORX Tools WU162.9 - Инструкция (Страница 11)

Cordless drill ENG
OPERATING
INSTRUCTIONS
1. CHARGING YOUR BATTERY PACK
Warning:The charger and battery pack
are specifically designed to work together
so do not attempt to use any other devices.
Never insert or allow metallic objects into your
charger or battery pack connections because an
electrical failure and hazard will occur.
2. BEFORE USING YOUR CORDLESS DRILL
Your battery pack is UNCHARGED and you must
charge once before use. Your battery pack will
not be fully charged until you have performed
several charge and discharge operations by
charging & working with your drill. After this
your battery pack performance will improve.
3. HOW TO CHARGE YOUR BATTERY PACK
CHARGING PROCEDURE
1)Plug the charger into an appropriate outlet.
The red light (10) will flash for 1 second and
then go out.
2)Insert the battery pack into the charger , the
red light (10) will stay on to indicate the charging
process has started.
3)On completion of charge the red light (10) will
change to continuous green. The pack is now
fully charged ,unplug the charger and remove
the battery pack
CHARGING INDICATOR
This charger is designed to detect some
problems that can arise with battery packs.
Indicator lights indicate problems (see table
below). If this occurs, insert a new battery pack
to determine if the charger is OK. If the new
battery charges correctly, then the original pack
is defective and should be returned to a service
center or recycling service center. If the new
battery pack displays the same problem as the
original Battery Pack, have the charger tested at
an authorized service center.
Light ON/OFF
flash
Status
Red on Charging
Red slow
flash
- - - - - Dead battery
Red fast
flash
-------------
Battery failure or char-
ger invalidated
Green on Charging complete
Green
slow flash
- - - - -
Hot/Cold delay; weak
battery repair; battery
abnormal
Green
fast flash
------------- Charging battery too hot
HOT/COLD BATTERY PACK DELAY
This charger has a HOT/COLD battery pack delay
feature. When the charger detects a battery pack
that is too hot or cold (the green light will flash
slowly), it automatically starts a HOT/COLD Pack
Delay, and suspends charging until the battery
pack has reached the correct temperature.
The charging process will then automatically
begin (red light ON continuously). This feature
ensures maximum battery life.
LEAVING THE BATTERY PACK IN THE
CHARGER
If a fully charged battery pack is left in the
charger, the green light (9) will remain ON. The
battery pack will remain charging with a current
of about 150mA.
NOTE: A battery pack will slowly lose its charge
when kept out of the charger or left in an
unplugged charger. It may need to be recharged
before use.
WEAK BATTERY PACKS
This charger will detect a weak battery pack.
When a weak battery pack is inserted into the
charger, the charger will try to repair it. This
process will last about 30mins (the green light
will flash slowly). When the repair is finished, it
will automatically begin to charge the battery
pack to the highest capacity possible (the red
light stays ON). If the green light (9) flashes for
more than 30mins, the red light (a) will begin to
flash slowly indicating the battery pack is dead.
NOTE: Repaired battery packs are still usable
but should not be expected to perform as much
work as new battery packs.
11 10
RUS-WU162 WU162.1 WU162.2 WU162-M-060726.indd 11 2006-7-26 13:42:30