Reciprocating saw eng, Symbols, Operating instructions – Инструкция по эксплуатации WORX Tools WU400
Страница 8
Reciprocating Saw ENG
WARNING: Some dust particles
created by power sanding, sawing,
grinding, drill and other construction jobs
contain chemicals known to cause cancer,
birth defects or other reproductive harm.
Some examples of these chemicals are:
- Lead from lead-based paints.
- Crystalline silica from bricks and cement and
other masonry products.
- Arsenic and chromium from chemically
treated lumber.
Your risk from these exposures varies,
depending upon how often you do this type
of work. To reduce your exposure to these
chemicals:
- Work in a well-ventilated area.
- Work with approved safety equipment,
such as those dust masks that are specially
designed to filter microscopic particles.
SYMBOLS
Read the manual
Warning
Wear eye protection
Double insulation
Wear hearing protection
Wear dust mask
OPERATING INSTRUCTIONS
1. ON/OFF SWITCH
Depress the button to start and release it to stop
your tool.
2. VARIABLE SPEED CONTROL
Your tool is equipped with a variable speed
controlled trigger switch. The tool can be turned
“ON” or “OFF” by squeezing or releasing the
trigger. The blade plunger stroke rate can be
adjusted from the minimum to maximum by
the pressure you apply to the trigger. Apply
more pressure to increase the speed and
release pressure to decrease speed (See A)
3. HAND GRIP AREAS
Always hold your saw firmly with both hands
when operating (See A).
4. TOOL-LESS BLADE FITTING
To install the blade (See B and C), disconnect
the saw from power supply. If necessary,
extend the pivoting blade foot away from the
blade clamp for easier access. Pull the tool-less
blade clamp lever (3) up with your thumb, as
shown. Insert the blade into the saw’s blade
clamp and make sure that the blade attaches
to the blade pin inside the clamp. Push down
blade clamp lever (3) ensure the blade is locked
securely in place.
To remove Blade (See B and C)
Disconnect saw from power supply. If necessary,
extend the pivoting blade foot away from the
blade clamp for easier access. First, pull the
blade clamp lever (3) up with your thumb, and
then pull the blade out of the blade clamp.
5. PIVOTING FOOT PLATE ADJUSTMENT
If you need to reduce the cutting capacity of
your tool (depth of cut), the pivoting foot plate
(4) may be adjusted as follows.
Press the pivoting foot plate release button
(6) on the underside of the front housing
(See D). Slide the pivoting foot plate forward
or backwards to give the required distance
from the end of the blade (See D). Release the
pivoting foot plate release button. The pivoting
foot plate is now locked in position but will
continue to pivot as it follows the work surface
during the cut. The distance from the front of
the foot plate to the tip of the blade (on the
longest part of the cutting stroke) equals the
cutting capacity of the tool.
09
08
RU-WU400-M-060821.indd 8
2006-8-21 17:33:14