Petsafe Spray Commander - Инструкция (Страница 36)

- 36 - - 36 - www.innotek.net
try, nor for subsequent use. Keep your dog away while you prepare the device as well as when you
fi ll it or change the battery.
• Make sure the device is always ready to function, should the dog display undesirable behaviour.
We recommend that you verify the device every day to make sure it contains enough spray.
• Put the collar around the dog’s neck at least 20 minutes before the training session begins so that
the dog doesn’t associate wearing the spray collar with the exercises.
IMPORTANT : To save battery power, turn off the device while not in use.
1. The Innotek ® Spray Commander ® Remote Spray Trainer is not a toy. Keep it away from the reach
of children. Use it only for its training purpose.
2. The Innotek ® Spray Commander ® Remote Spray Trainer must be used only on healthy dogs. We
recommend that you take your dog to a veterinarian before using the Innotek ® Spray Commander ®
Remote Spray Trainer if he is not in good health.
3. The receiver collar is waterproof. It is however recommended to keep device away from water as
much as possible. Note that the remote control is not waterproof.
4. Keep the device clean at all times. Simply use a dry cloth to wipe away dirt.
5. Do not leave your device unattended where your dog could get a hold of it and damage it through
chewing.
6. Always make sure that the batteries you are using are still adequate to operate the device. The
device requires 6-volt alkaline batteries, easily available from Innotek ® .
7. Never fi ll the device with any other substance than the one provided by Innotek ® . Using another
substance, as well as opening the device, will void the manufacturer’s warranty.
8. If your dog tries to take off the device, a harness can be used instead of the collar provided in the kit.
9. The hypo-allergenic spray can is a pressurized container. Do not pierce it, heat it or dispose of it
in a fi re as it may explode. Please read instructions on the can.
10. Do not expose the device neither to freezing temperatures nor to conditions warmer than
113°F/45°C. Be particularly careful not to leave the device in direct sunlight, either by a window
or in a car on a summer day, etc.
11. Do not attempt to repair the device yourself. This will invalidate the warranty and make repairing
more diffi cult. If the device doesn’t work, please contact our Customer Care Centre.
If you have problems with your Innotek ® Spray Commander ® Remote Spray Trainer:
1. Make sure that both the device (receiver collar) and the transmitter (remote) have the same ID
number (01 to 08) (ex. R912 ID 03 for the receiver, and T912 03 for the transmitter).
2. Place a new battery into the receiver collar. Fill the device, then turn it on.
3. Press button 1 on the remote control; the receiver collar should emit a beep.
IMPORTANT REMARKS IMPORTANT REMARKS
The device is activated by radio signals sent by the remote control. The strength of the signal may be
affected by environmental conditions, topological features and electromagnetic interference.
This being a radio frequency device, battery consumption can be elevated.
TROUBLESHOOTING GUIDE TROUBLESHOOTING GUIDE