Setting and starting a washing programme – Инструкция по эксплуатации Electrolux ESF2430W

Страница 10

Advertising
background image

Programme

Programme duration

(in minutes)

Energy consumption

(in kWh)

Water consumption

(in litres)

D

50°

36

0,40

6

E

40°

31

0,35

6

1) Test programme for test institutes

The consumption values are intended as
a guide and depends on the pressure
and the temperature of the water and al-

so by the variations of the power supply
and the amount of dishes.

Setting and starting a washing programme

Do these steps to set and start a washing
programme:
1. Close the door.
2. Turn the programme knob to set the

washing programme. Refer to the chap-
ter 'Washing programmes'.
– The on/off indicator light comes on.
– The phase indicator light for the wash-

ing programme starts to flash.

3. Press the start/cancel button.

– The washing programme starts auto-

matically.

– The start/cancel indicator light comes

on.

– When the programme starts, only the

phase in progress indicator light stays
on.

When the washing programme oper-
ates, you cannot change the pro-
gramme. Cancel the washing pro-
gramme.

Warning! Only interrupt or cancel a
washing programme if necessary.

Caution! Open the door carefully. Hot
steam can come free.

Cancelling a washing programme
• Press and hold the start/cancel button for

approximately 5 seconds.
– The start/cancel indicator light goes off.
– The phase indicator lights starts to flash.
The washing programme is cancelled.
At this time you can do these steps:
1. Switch off the appliance.
2. Set a new washing programme.

Fill the detergent dispenser with detergent
before you set a new washing programme.

Interrupting a washing programme
Open the door.
• The programme stops.
Close the door.
• The programme continues from the point

of interruption.

Setting and starting a washing
programme with delay start
1. Set a washing programme.
2. Press the delay start button.

– The delay start indicator light comes

on.

3. Press the start/cancel button.

– The countdown of the delay start

starts.

– The phase indicator lights go off.

When the countdown is completed, the
washing programme automatically starts.
• The delay start indicator light goes off.
• The phase indicator light comes on.

Do not open the door during the count-
down to prevent interruption of the
countdown. When you close the door
again, the countdown continues from
the point of interruption.

Cancelling a delay start:
1. Press and hold the start/cancel button for

approximately 5 seconds.
– The start/cancel indicator light and de-

lay start indicator light go off.

– The phase indicator lights start to flash.

2. Press the start/cancel button to start the

washing programme.

10 electrolux

Advertising