Hyundai H-1547 - Инструкция (Страница 3)

2 3
Instruction manual Instruction manual
Important safeguards
• The instruction manual contains important
operating and maintenance instructions. For
your safety, it is necessary to refer the manual.
Keep the manual for use in future.
• Do not hit or drop the unit.
• Do not expose the unit to vibration,
direct sunlight, too high or low temperature or
humidity.
• If you are not going to use the unit within
a long period of time, remove the batteries to
avoid their leakage.
• Do not disassemble the unit yourselves.
Refer servicing to qualified service personnel.
Power supply
Battery operation
• Insert 1 battery Cr2032 (included) to the
battery compartment (remove the screw). The
set will not work normally from the battery
supply, but there is now the advantage that, in
case there is a mains current failure, your clock
will continue to work. The clock display will not
light up, the clock time will be held in the clock
memory by the battery back-up system. This
enables you to move the set from place to place
without re-setting the clock every time. The
battery back-up system is only meant to be used
from short temporary power failures. For longer
durations the battery may become exhausted or
there may be deviation in accuracy.
• When the battery is exhausted, it should
be removed from the set to prevent leakage.
If you do not wish to take advantage of the
battery back-up system, your set will work
normally without a battery. However, if
disconnected from the mains, the clock figures
will flash when the mains are re-connected and
you must re-set the clock.
AС operation
• Before the first connecting of the appliance
check that voltage indicated on the rating label
corresponds to the mains voltage in your home.
• Plug the corresponding end of cord into
the power socket on the rear of the set.
• Insert the plug into power supply.
Setting the clock
Set ALARM MODE switch to BUZZER
position. Press and hold TIME button until
hour digits flash. Press repeatedly
/CLOCK/
ALARM- and /CLOCK/ALARM+ buttons to
set hours. Press TIME button to save hours;
minute digits will flash. Press repeatedly
/CLOCK/ALARM- and
/CLOCK/ALARM+
buttons to set minutes. Press and hold TIME
button to save minutes.
Radio operation
Tuner operations
• Set ALARM MODE switch to RADIO
position; the Radio indicator on the display will
light up.
• Press TIME button to switch on the radio.
• Press RANDOM/SCAN button once to
begin searching and saving of up to 40 radio
stations automatically.
• Briefly press /CLOCK/ALARM- button
or /CLOCK/ALARM+ button to select
previous or next preset station.
• Press and hold for 3 seconds /CLOCK/
ALARM- button or /CLOCK/ALARM+ button
for automatical search of the nearest station
with strong signal down or up the range.
• Press PRE./TUN. button to switch between
radio frequency and preset position; when
frequency is displayed you can tune stations
manually with
/CLOCK/ALARM- and /
CLOCK/ALARM+ buttons.
• To save a station, press and hold PROG
button until display blinks, press /CLOCK/
ALARM- button or /CLOCK/ALARM+ button
to change preset position, briefly press PROG