VICONTE vc-443 - Инструкция (Страница 3)

ImPORTaNT CauTION
• Read this manual carefully before operating this unit.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack
of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person
responsible for their safety.
• Children should be supervised to ensure that they do not play with the appliance.
• Before using this unit, check the mains power voltage corresponds to the voltage shown on the marking plate.
• Always remove the plug from the power socket when this unit is not in use and before carrying out any cleaning or maintenance
operation.
• Never leave this unit unattended when it is switched on. Keep this unit out of the reach of the children.
• Do not switch the appliance on if it appears to be faulty in any way.
• For repairs, accessories or power cord replacement, contact your dealer or an authorized Service Center.
• It is not allowed to immerse the base into water for cleaning and it is forbidden to start the unit or press the control button by wet
hands.
• The water temperature should not be over 60° when cleaning the unit.
• Do not run this unit long-time, otherwise the inner parts will be damaged.
• When the motor is running, do not insert your finger or other objects into the machine and container.
• The instructions for food processors and blenders shall warn of potential injury from misuse. they shall state that care shall be
taken when handing the sharp cutting blades, emptying the bowl and during cleaning.
• Switch off the appliance and disconnect from supply before changing accessories or approaching parts that move in use.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to
avoid a hazard.
INSTRuCTION FOR uSE
ChoppeR
• place the chopper cup on a dry and horizontal surface. put the chopping blades in the chopper cup. (Note: Do not use blender)
• put the meat (cut into small piece with 10-20mm thickness, without bone and muscle) into the chopping cup (the volume of food
should not be more than 300g ) and then close the chopper cover. And with the base connection.
• Turn on the power, start switch moving fast points (namely move 2-3 seconds, 2-3 seconds) 3 ~ 5 times, After continuous operation.
• When the food has been cut into desired pieces, turn off the unit. After the motor stop running, remove the container and take
out the food.