Care and maintenance, Spray, Auto stop – Инструкция по эксплуатации Binatone SI-4060
Страница 6: Ionized steaming function, Cleaning of the sole plate, Cleaning of internal parts of the appliance
6
66
66
button (8)
(8)
(8)
(8)
(8) to produce a directional strong burst of steam from
the sole plate. Push the button several times with 5-7 seconds
intervals until the article is fully refreshed. If during the process
your water tank (5)
(5)
(5)
(5)
(5) runs out of water, disconnect the appliance
from the mains outlet, wait till it cools down, refill the tank and
plug the appliance back into the power supply and continue the
process.
Spray
Using the water spray (7) will help when ironing details of the
article (cuffs, trimmings, plackets, etc) or clothes, which demand
«•» (low temperature) ironing, when steam ironing is not possible.
Push the button several times to moisten the material.
Auto stop
For safety reasons, your iron will automatically stop heating if
it’s left:
!
upright for 8-15 minutes, or
!
flat for 10-30 seconds.
The Operation indicator (1
(1
(1
(1
(11)
1)
1)
1)
1) will flash. The iron will heat up
again when you move it and the operation light will go out.
!
To deactivate automatic shut off, stand iron on heel or shake
gently, then the iron will switch on again.
Ionized steaming function
In the dry ironing and steam ironing of process can be used the
ionized steaming function.
Press and hold on the control button (16)
(16)
(16)
(16)
(16) of the ionized steaming
function. The blue internal indicator (17)
(17)
(17)
(17)
(17) turns on in this case show-
ing that smaller steam particles, deeply get into the most difficult
ironing fold, and eliminate the wrinkle to be easier. Light clicking
during this process is a normal occurrence and not a malfunction.
5. When you have finished cleaning or ironing, do not forget to
switch the iron off by putting the steam control knob (9)
(9)
(9)
(9)
(9) and the
temperature control knob (10)
(10)
(10)
(10)
(10) into the «0» position and un-
plugging the appliance from the mains supply outlet.
CARE AND MAINTENANCE
Cleaning of the sole plate
Do not use any abrasive substances and ma-
terials to clean the sole plate.
Cleaning of internal parts of the
appliance
SI-4060 iron is equipped with an anti-scale function which
protects it from an accumulation of scale: it does this with a built-in
permanent filter. Therefore the water hardness is reduced and the
useful service life of the iron is extended.