Vitek VT-3518 - Инструкция (Страница 4)

the minutes) or to the right (to
set the hours). When the time
has been set, move the
RUN/ALM/TIME (5) selector
back to RUN. The two blinking
dots on the display (7) should
stop blinking.
SETTING THE CURRENT TIME
FOR THE PROJECTOR
Attention! Òhe current time
shown on the display and that
projected by the projector must
be set separately.
Projector:
Set the projector selector (14) to
the ON position. Press and hold
the T button (18); press the H
(16) button to set the hours and
the M (15) button to set the min-
utes. Switch the projector selec-
tor (14) to the OFF position to
turn the projector off.
Note: The time displayed by the
projector on the wall or ceiling
can be easily seen in a dark
room. The maximum projection
distance is 0.6 – 2.7 m. Use the
focus control dial (17) to adjust
the brightness and focus of the
projected image.
SETTING THE ALARM TIME
In order to set the current time,
move the RUN/ALM/TIME (5)
selector to the ALARM position and
turn the dial (8) to the left (to set the
minutes) or to the right (to set the
hours). When the time has been set,
move the RUN/ALM/TIME (5)
selector back to RUN. The two
blinking dots on the display (7)
should stop blinking.
ATTENTION!
Do not rotate the dial to fast
because the clock cannot react
at high speeds.
WAKING UP TO MUSIC
1. Set the ON/AUTO/OFF (6)
selector to the AUTO position.
2. Tune to the desired station
by rotating the frequency-
tuning knob (10).
3. Set the desired volume by
rotating the knob (12).
4. The radio will turn on at the
pre-set time.
WAKING UP TO THE BUZZER
ALARM
1. Set the ON/AUTO/OFF (6)
4
ENGLISH
3518.qxd 12.02.2005 23:41 Page 4