Sony KV-SR29 - Инструкция (Страница 33)

33 Additional Information
x Troubleshooting
If you find any problem while viewing your TV, you can either use the Reset
function or check the Troubleshooting guide below. If the problem persists,
contact your Sony dealer.
Reset function
Press the RESET button on your remote control.
Your TV will go blank for a few seconds,
then the “Initial Setup” menu will appear.
Pressing RESET will set your TV to the factory
setting, but certain problems may be solved.
Troubleshooting guide
Snowy picture
Noisy sound
Distorted picture
Noisy sound
Good picture
Noisy sound
Possible cause Symptom Solutions Page
30
–
27
27
–
–
27
27
13
• Check the antenna cable and connection
on the TV, VCR and at the wall.
• Check the antenna setup.
Contact a Sony dealer for advice.
• Display the “Channel Setup” menu and
select “Manual Program” to preset the
channel again.
• Display the “Channel Setup” menu and
set the “Signal Booster” to “Auto” from
“Manual Program”.
• Try using an external booster.
• Turn off or disconnect the external booster
if it is in use.
• Display the “Channel Setup” menu and
set the “Signal Booster” to “Off” from
“Manual Program”.
• Display the “Channel Setup” menu and
select the appropriate “TV System” from
“Manual Program”.
• Press or .
• The connection is loose
or the cable is
damaged.
• The antenna setup is
inappropriate.
• Channel presetting is
inappropriate or
incomplete.
• Signal transmission is
low.
• Broadcast signals are
too strong.
• The TV system setting
is inappropriate.
• PIP sound is selected
when PIP is displayed.
7 8 9
0
TV
PROG
OPTION RESET
RESET
continue