ZELMER 39Z012 - Инструкция (Страница 46)

46
3. Using the clipper for hair cutting and thinning
TIP: Cut the hair for demanded length in stages, start form bigger length.
Insert appropriate comb attachment (small – (IV) or big (V)).
A small comb attachment – (IV) is good for cutting hair from 4–20 mm, whereas the big one (V) from 24–40 mm (see: Comb attachments inserting/
replacing).
Switch the device on moving the ON/OFF switch – (3) to 1 position.
Cut only small areas. –
Move the clipper slowly along hair. –
Hold the device so, that the comb attachment is laid flat. –
Always start the cutting from the neck upwards or from the forehead and temples upwards to the top of head. –
In order to thin the hair turn the hair thinning knob
(2) to ; position; the thinning attachment integrated with cutting head (1) shall be moved up.
You can reduce the hair volume with this feature. It provides a modern, changed look without the change of hair length.
4. Cutting hair without attachment
WARNING: The cutting head (1) is very sharp. Injury hazard!
You can cut the hair in uniform length of 1–2 mm without comb attachment.
For clipping the hairline of bristle and whiskers, neck shaving:
Move the hair clipper slowly along hair. –
Turn the device so, that the back part was directed upwards. –
Place the edge of the cutting head – (1) without comb attachment on desired length of bristle hairline.
Move down the clipper in operation. –
5. Comb attachments inserting/replacing
It is possible to select one of two comb attachments:
The small attachment can cut hair for the length of: 4 mm, 7 mm, 10 mm, 13 mm, and 16 mm. ●
The big attachment can cut hair for the length of: 18 mm, 21 mm, 24 mm, 27 mm, and 30 mm. ●
Insert an attachment into the side runners of the hair clipper housing.
–
At the bottom of the comb attachment there is an oval setting bar. Press it with your thumb and simultaneously push the attachment into desired –
position.
Before you start cutting, make sure that the attachment is firmly blocked. –
Replace one attachment removing it and inserting another as described above. –
In order to shorten hear or beard more, move down the attachment into another position and repeat the cutting process. –