ZELMER 39Z014 - Инструкция (Страница 46)

46
When the accumulators are fully loaded, 5 diodes glow. Whereas, one diode glows, it means that the accumulator should be unloaded soon. –
The hair clipper accumulator obtains optimum power after three cycles of loading and unloading. Ten hours is enough for next loading. In order to –
provide long life of accumulators, they should be completely unloaded before loading.
3. Using the clipper for hair cutting and thinning
TIP: Cut the hair for demanded length in stages, start form bigger length.
Insert an appropriate attachment (III, IV, V, VI, VII, and VIII). –
Set the desired length of hair/beard cutting with cutting length adjustment knob – (2).
Start up the hair clipper pressing in ON/OFF button – (4).
Cut only small areas. –
Move the clipper slowly along hair. –
Hold the device so, that the comb attachment is laid flat. –
Always start the cutting from the neck upwards or from the forehead and temples upwards to the top of head. –
In order to thin hair insert the thinning attachment
(III) on cutting head.
You can reduce the hair volume with this feature. It provides a modern, changed look without the change of hair length.
4. Cutting hair without attachment
WARNING: The cutting head (1) is very sharp. Injury hazard!
You can cut the hair in uniform length of 1–2 mm without comb attachment.
For clipping the hairline of bristle and whiskers, neck shaving:
Move the hair clipper slowly along hair. –
Turn the device so, that the back part was directed upwards. –
Place the edge of the cutting head – (1) without comb attachment on desired length of bristle hairline.
Move down the clipper in operation. –
5. Comb attachments inserting/replacing
You can select one of six attachments (See: Outline and parts of hair clipper):
Select the attachment according to the length of cutting. –
Insert appropriate attachment into the sides of the device. The protrusions shall be locked inside small holes (see the –
figure beside) on left and right sides.
Replace one attachment removing it and inserting another as described above. –
In order to remove an attachment bent one side of assembled attachment gently and then move it up. –
Move the cutting length adjustment knob – (2), to increase/reduce the hair cutting length. The possible hair cutting length
is indicated on each attachment (i.e. 4–6 mm).