Инструкция по эксплуатации ZELMER 28Z025
Страница 65
65
GW28-022_v01
How to fill the water
Disconnect the iron from mains
–
supply outlet.
Move the
–
steam Control Knob
(4) to position.
Release the
–
water inlet cover (8)
and fill water through the water
inlet hole.
Fill up to the „
–
MAX” level marked
on the side of water tank.
Close the
–
water inlet cover (8).
Temperature setting
Connect the iron to a suitable mains supply outlet.
–
The
–
display (5) glows for a moment and you can hear single sound sig-
nal. Then the
display (5) go off.
Press the
–
button on the left side of the display, to switch
it on you can hear a single sound signal. Number, type of garment and
amount of dots referring to the temperature level.
To set the temperature use
–
and
buttons, located
at both sides of the display.
In order to increase the temperature press
–
button many
times (a sound signal goes with every click). The following labels shall
appear on
display (5): acrylic, nylon, silk, polyester, blend, wool, cotton,
jeans, linen.
In order to reduce the temperature press
–
button many times
(a sound signal goes with every click). The labels shall appear on dis-
play in reverse sequence.
Dots
–
indicate the temperature setting.
Preparation for operation – first ironing
Remove any protective films or sticker from the
–
soleplate (1) and the
cabinet.
Unwind and straighten the
–
power cord (12).
Fill the water tank in as described under “
–
How To Fill Water”.
The
–
display (5) glows for a moment and you can hear single sound sig-
nal. Then the
display (5) go off.
Press
–
button to set the temperature on display
.
When the temperature is reached the number stops blinking and you
–
can hear a single sound signal.
Move the
–
Steam Control Knob (4) to position.
Steam starts coming out from the holes in the sole plate after putting the
–
iron in horizontal position and after
Burst of steam knob (3).
Begin first time ironing with an old towel.
–
The steam is not generated after the water tank is emptied.
–
The preparation work is completed. The iron is now ready for proper
–
use.
After operation press and hold
–
button for about 2 sec-
onds to switch off the iron. You can hear single sound signal. Then the
display (5) goes off.
Move the
–
Steam Control Knob (4) to
position.
Disconnect the iron from mains supply outlet.
–
When the iron gets cool completely, store it vertically in a safe place.
–