Vitek VT-3486 - Инструкция (Страница 5)

GETTING STARTED
CONNECTING THE SPEAKERS
Connect the right-speaker cable (47) to the right-speaker jack (45) on the rear panel of the system.
Connect the left-speaker cable (48) to the left-speaker jack (46) on the rear panel of the system.
The speakers can be mounted on the wall using the mounting holes located on the rear panels of the
right and left speakers (49,50).
HOW TO PUT BATTERIES IN THE REMOTE CONTROL
Insert ÀÀÀ batteries in the Remote Control; match the polarity on the batteries with the corresponding
markings in the battery compartment.
AM ANTENNA
An AM antenna is located inside the unit. Rotate the unit so as to obtain the best reception of AM radio
stations.
FM ANTENNA
Extend the antenna to its full length to obtain the best reception of FM radio stations.
STEREOPHONE JACK
For private listening , connect stereophones (not provided) to the corresponding jack (11). Adjust the
required volume level using the volume controls. After connecting the stereo phones, the sound from
speakers switches off automatically.
TURNING THE SYSTEM ON AND OFF
Press the POWER ON button (1) to turn the system on and the Power indicator (8) will light up.
Press the POWER ON button (1) again and the system will turn off.
BASS EXTENSION SYSTEM XBS
Press the On/Off bass extension button XBS (12) to enrich the sound.
VOLUME
To adjust the required volume level , press and hold VOLUME+ (13) or VOLUME- (14) control, or
respectively R13 or R15 on the Remote Control.
ANTI-SHOCK FUNCTION
The playback interruption protection can be activated in CD/MP3 mode only. The maximum period of
the function is 20 seconds.
CD PLAYBACK
Using the Function switch (CD/CASSETTE/RADIO) (2) select CD playback mode. After that CD will turn
on, and " " will blink on the display as shown in FIG. 1.
[FIG. 1.]
Should there be no disc in the CD compartment, the " " indication lights up on the LCD display, as
shown in fig. 2.
[FIG.2.]
4
ENGLISH
3486.qxd 24.09.2004 18:05 Page 4