Safety – Инструкция по эксплуатации Kenwood CM900

Страница 5

Advertising
background image

safety

Watch out for steam and

never lift the filter holder lid

during the brewing cycle.

Never touch the hotplate.

Always lift the filter holder lid using
the opening tab

ቯ.

Never touch hot surfaces.

Keep children away from the
machine. And never let the cord
hang down where a child could
grab it.

Wind excess cord into the cord
storage device

ᕡ.

Never use a damaged machine. Get
it checked or repaired: see ‘service’.

Never put the machine in water or
let the cord or plug get wet - you
could get an electric shock.

Switch off and unplug:

before filling with water

before cleaning

after use.

Never leave the machine on
unattended.

Don’t let the cord touch hot parts.

Don’t let infirm people use the
machine without supervision.

Don’t let children play with this
machine.

Only use the machine for its
intended domestic use.

Always make sure there is water in
the tank before switching on.

This coffee maker is only suitable for
use with the type of carafe supplied.

Do not leave the machine switched
on with an empty carafe on the
hotplate.

Never put the carafe in the
microwave.

before plugging in

Make sure your electricity supply is
the same as the one shown on the
underside of your machine.

This machine complies with
European Economic Community
Directive 89/336/EEC.

before using for the first time

1 Remove all packaging.
2 Wash the parts: see ‘care and

cleaning’.

3 Wind excess cord into the cord

storage device

ᕡ.

4 Run two lots of water through the

machine (without coffee) to clean it
out. Fill the tank to the top cup mark
when you do this. See ‘to make
coffee’.

key

ቢ permanent filter
ባ filter holder lifting tab
ቤ filter holder
ብ anti-drip valve
ቦ coffee measuring spoon
ቧ hotplate
ቨ glass carafe and lid
ቩ on/off switch with power light
ቪ de-scale warning light
ቫ cord storage device
ቭ water tank
ቮ water tank lid
ቯ filter holder lid opening tab
ተ de-scale reset button

to make coffee

1 Lift the tank lid and fill with the

required amount of water. The water
level must be between the top and
bottom cup marks. Do not fill above
the MAX level.

Use cold water. We recommend
using filtered water from a Kenwood
Water Filter as it reduces limescale
and prolongs the life of your coffee
maker. Never use warm or fizzy
water.

2 Ensure the filter holder is positioned

correctly.

3 Fit either the permanent filter

supplied or a paper filter into the
filter holder. Add the coffee, use the
spoon provided (approximately 1
level spoon per cup or to taste).

4 Close the lid and put the carafe on

the hotplate.

2

Advertising