Candy GOY 105 TXT - Инструкция (Страница 74)

74
Trouble shooting
What might be the cause of…
Defects you can remedy yourself
Before calling GIAS Service for technical advice please run through the following checklist. A
charge will be made if the machine is found to be working or has been installed incorrectly or used incorrectly.If
the problem persists after completing the recommended checks, please call the GIAS Service, they may be
able to assist you over the telephone.
FAULT CAUSE REMEDY
Plug not in socket. Plug it in.
1. Does not function on any
program
Not switched on.
Turn on mains switch
Power failure. Check and refer to “Power Fail-
ure” section.
Fuse blown. Check.
Door open. Close door.
RCD tripped (trip switch) Reset RCD.
Has the Delay start been set. Check.
See cause 1. Check.
2. Does not load water
Water supply turned off. Turn on water supply.
Program selector not correctly posi-
tioned. Position program selector
correctly.
Kink in discharge hose. Straighten discharge hose.
3. Does not discharge water
Foreign bodies in filter Examine filter.
The machine has been plumbed in
incorrectly. Check installation.
4. Water on floor around
washing machine
Leaking gasket between tap and water
inlet hose. Replace gasket and tighten con-
nection.
Strand of clothing or dirt between door
rubber gasket and door glass. Re-load the machine and keep
rubber door gasket/door glass
clean.
Incorrect plumbing. Check plumbing.
Water has not yet drained away. Wait a few minutes for machine to
empty.
5. Does not spin
“Spin Cancel” option selected (certain
models only). Check.
Unbalanced load. Rearrange load evenly.
6. Machine vibrates a lot
during spin Washing machine not completely level. Adjust the special adjustable feet.
Load not distributed evenly. Rearrange the laundry evenly.
Transit brackets not removed. Remove transit brackets (see
installation section).
7. Door will not open Two minutes have not elapsed since
the program finished. Wait two minutes.
7. Display reads error
0, 1, 5, 7, 8, 9 - Call service.
8. Display reads error 2 No water fill. Check water supplies are on.
9. Display reads error 3 No pump out. Check drain is clear.
Check drain hose is not kinked.
10. Display reads error 4 Machine overfilled with water. Turn off water supply to machine.
Call service.