Инструкция по эксплуатации Polaris PCH 1064G
Страница 13
Advertising
13
IV.
Installation
•
Install the horizontal beam into the holes of hold-down bars. Note the
direction.
•
Put the mounting panel on the fixed position on the wall.
•
Using a pencil to mark the point on the wall for the hole.
•
Drill the first hole.
•
Insert the soft mounting into the hole.
•
Tighten screws.
•
Aim the hole of back panel and the hole of the mounting panel.
•
Install the under hole first.
•
Then the upper one.
•
After finishing screw down with two special screw.
Advertising