3installation, Before operating your refrigerator, Electric connection – Инструкция по эксплуатации Beko FN 123400

Страница 9

Advertising
background image

EN

8

3

Installation

B

Please remember that the

manufacturer shall not be held liable if
the information given in the instruction
manual is not observed.

Points to be considered

when re-transporting your

refrigerator

1.Your refrigerator must be emptied and

cleaned prior to any transportation.

2.Shelves, accessories, crisper and etc.

in your refrigerator must be fastened
securely by adhesive tape against any
jolt before repackaging.

3.Packaging must be tied with thick

tapes and strong ropes and the
rules of transportation printed on the
package must be followed.

Please do not forget…
Every recycled material is an

indispensable source for the nature
and for our national resources.

If you wish to contribute to recycling

the packaging materials, you can
get further information from the
environmental bodies or local
authorities.

Before operating your

refrigerator

Before starting to use your refrigerator

check the following:

1.Is the interior of the refrigerator dry and

can the air circulate freely in the rear
of it?

2.Please install the 2 plastic wedges

as illustrated in the figure. Plastic
wedges will provide the required
distance between your refrigerator
and the wall in order to allow the air
circulation. (The illustrated figure is
only an example and does not match
exactly with your product.)

3.Clean the interior of the refrigerator as

recommended in the “Maintenance
and cleaning” section.

4.Plug the refrigerator into the wall outlet.

When the fridge door is open, the
fridge compartment interior light will
come on.

5.You will hear a noise as the

compressor starts up. The liquid and
gases sealed within the refrigeration
system may also give rise to noise,
even if the compressor is not running
and this is quite normal.

6.Front edges of the refrigerator may feel

warm. This is normal. These areas
are designed to be warm to avoid
condensation

Electric connection

Connect your product to a grounded
socket which is being protected by a
fuse with the appropriate capacity.
Important:
• The connection must be in compliance

with national regulations.

• The power cable plug must be easily

accessible after installation.

• The specified voltage must be equal to

your mains voltage.

Advertising
Эта инструкция подходит к следующим моделям: