Elenberg FR-0409 - Инструкция (Страница 11)

11
BeFOre USINg yOUr Freezer
• Remove the exterior and interior packing.
• Check to be sure you have all of the following parts:
4 Baskets
1 Instruction Manual
• Before connecting the freezer to the power source, let it stand upright for
approximately 2 hours. This will reduce the possibility of a malfunction in the
cooling system from handling during transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
INSTALLATION OF yOUr Freezer
• Place your freezer on a floor that is strong enough to support the freezer
when it is fully loaded. To level your freezer, adjust the legs at the front of
the freezer.
• Allow 5 inches of space between the back and sides of the freezer, which al-
lows the proper air circulation to cool the compressor.
• Locate the freezer away from direct sunlight and sources of heat (stove,
heater, radiator, etc.). Direct sunlight may affect the acrylic coating and heat
sources may increase electrical consumption. Extreme cold ambient tem-
peratures may also cause the freezer not to perform properly.
• Avoid locating the freezer in moist areas. Too much moisture in the air will
cause frost to form quickly on the evaporator requiring more frequent de-
frosting of the freezer.
• Plug the freezer into an exclusive properly installed-grounded wall outlet. Do
not under any circumstances cut or remove the third (ground) prong from
the power cord. Any questions concerning power and or grounding should be
directed toward a certified electrician.
eLeCTrICAL CONNeCTION
Warning:
Improper use of the grounded plug can result in the risk of electrical shock.
If the power cord is damaged, It must be replaced by the manufacturer, its
service agent or similarly qualified persons in order to avoid a hazard.
• This freezer should be properly grounded for your safety. The power cord of
this freezer is equipped with a three-prong plug which mates with standard
three prong wall outlets to minimize the possibility of electrical shock.
• Do not under any circumstances cut or remove the third ground prong from
the power cord supplied.
• use of extension cords is not recommended.
• This freezer requires a standard 220/240 volt, 50 hz electrical outlet with
three-prong ground.
• The cord should be secured behind the freezer and not left exposed or dan-
gling to prevent accidental injury.
reverSINg The DOOr OF yOUr Freezer
This freezer can be opened either from the left or right side. The default way
of opening the door is from the right side. If you want to open the door from
the left side, please follow the instructions below.
NOTE:
All the removed parts must be well kept for the reinstallation of the
door.
INSTALLATION INSTrUCTIONS