Kenwood SJ375 - Инструкция (Страница 5)

safety
● Always use the filter and never
overfill – boiling water may splash
out.
● Avoid contact with steam coming
out of the spout area when pouring
and out of the lid when refilling.
● Beware: the metal body of the kettle
will get hot during operation.
● Keep small children away from the
kettle and never let the cord hang
down over the worktop edge - a
child could grab it and pull the kettle
down.
● If you do not need so much cord,
shorten it by wrapping any excess
cord around the bracket on the
underside of the powerbase
ቧ.
● Never put the kettle, powerbase,
cord or plug in liquid.
● Do not use if there is any damage
to the kettle, powerbase, cord or
plug. Get it checked or repaired: see
‘service’.
● This kettle is not intended for use by
young children or infirm persons
without supervision.
● Young children should be supervised
to ensure they do not play with the
appliance.
● Caution: Do not operate the kettle
on an inclined surface.
● Only use the powerbase supplied
and keep it clean and dry.
● Make sure the lid is secure before
switching the kettle on.
● Warning: Do not open the lid while
the water is boiling.
● Make sure the kettle is switched off
before lifting or pouring.
● Remove the kettle from the base
before filling or pouring.
● Never put the kettle near or on
cooker hot plates or gas burners.
● This kettle is for boiling water only.
● This kettle is for domestic use only.
● Failure to observe these cautions
may result in damage to the kettle.
before plugging in
● Make sure your electricity supply is
the same as the one shown on the
underside of your kettle.
important
● This kettle complies with European
Economic Community Directive
89/336/EEC.
before using for the first time
● Remove all packaging and any
labels.
● Fill to ‘MAX’, boil, then discard the
water. Repeat 2 to 3 times.
know your Kenwood
stainless steel kettle
ቢ finger pad
ባ flip top lid
ቤ lid catch release
ብ water level windows
ቦ on/off switch with neon
ቧ 360° powerbase
ቨ scale filter
ቩ cord wrap
to use your stainless
steel kettle
1 Fill the kettle through either the
spout or lid. To open the lid press
and hold down the lid release
ቤ.
The water level must be between
‘Max’ and 200 mls (1 cup)
● Be economical: do not boil more
water than you need.
● To improve the quality of your drinks
always use fresh water.
● Empty the kettle after each use.
2 Close the lid by pushing down on
the black finger pad area
ቢ.
3 Plug in and switch on. The neon light
will come on.
4 Your kettle will boil and switch off
automatically. To re-boil, wait a few
seconds - the on/off switch needs
time to reset.
2
English