Assembly and use, Cleaning – Инструкция по эксплуатации Kenwood JE700
Страница 6
assembly and use
1 Fit the pulp collector
ensuring the spout
ቨ and anti-
drip control
ቧ are to the front of the juicer.
2 Fit the filter inside the pulp collector
.
3 Put the lid on. Then turn the lid to the back of the juicer
until it locks
. Your juicer will not work if the lid
is unlocked.
4 Place the hopper onto the lid
. Note: The hopper can
be inverted for storage on the juicer
.
5 Push any excess cord into the compartment at the back
of the juicer.
6 Put the juice jug under the outlet. The froth separator
ቯ in the jug ensures that the juice is free from froth.
7 Cut the food into small pieces to fit the feed tube.
8 Press the anti-drip control up during juicing. After use, to
prevent the juice dripping, press the anti-drip control
down.
9 Push the lever
ቩ down to switch on and the light will
come on. Then push the food down using the pusher.
●
Some very hard foods may make your juicer slow down
or stop. If this happens switch off and unblock the filter.
●
Switch off and clear the pulp collector regularly during
use.
Reverse the assembly procedure to take the juicer apart.
Always unplug after use.
hints
●
Insert soft food slowly to get the most juice.
●
Vitamins disappear - the sooner you drink your juice,
the more vitamins you'll get.
●
If you need to store the juice for a few hours put it in
the fridge. It will keep better if you add a few drops of
lemon juice.
●
Don't drink more than three 230mls (8 fl.oz.) glasses of
juice a day unless you're used to it.
●
Dilute juice for children with an equal amount of water.
●
Juice from dark green (broccoli, spinach etc) or dark
red (beetroot, red cabbage etc) vegetables is extremely
strong, so always dilute it.
●
Fruit juice is high in Fructose (fruit sugar), so people
with diabetes or low blood sugar should avoid drinking
too much.
●
Don't mix fruit and vegetable juice together (apart from
apple and carrot) - it can cause painful wind or
bloating.
to use your citrus juicer
1 Fit the pulp collector
. To prevent leaking the pulp
collector must be fitted. Press the anti-drip control up
during juicing. After use, to prevent the juice dripping,
press the anti-drip control down.
2 Put the strainer inside the pulp collector - turn until it
locks
, then add the cone
.
3 Put the juice jug under the outlet.
4 Push the lever
ቩ down to switch on and the light will
come on. Cut the fruit in half. Then press each half
down on to the cone and the juicer will operate
automatically.
●
To help with juice extraction move the fruit from side to
side.
5 To stop the juicer lift the fruit from the cone.
●
When juicing large quantities, empty the strainer
regularly to prevent the build up of pulp and seeds.
Empty the juice jug as required.
important
●
Don’t press too hard on the cone or run
continuously for longer than 10 minutes - you
may damage your juicer.
cleaning
●
Always switch off, unplug and dismantle before
cleaning.
●
If the filter is too tight to remove, wait a few minutes
until it loosens up.
●
Do not wash any of the parts in the dishwasher.
●
Some foods, eg carrot, will discolour the plastic.
Rubbing with a cloth dipped in vegetable oil helps
remove discolouring.
motor unit
●
Wipe with a damp cloth, then dry.
pulp collector
●
Wash in hot soapy water.
filter
●
Clean using a soft brush.
●
Check the filter regularly for signs of
damage. Do not use if the filter is damaged.
Refer to “service and customer care”
other parts
●
Wash in hot soapy water.
Note: The hopper can be inverted for storage on the juicer
.
3