Whirlpool AWG 328 - Инструкция (Страница 36)

Failure code
Failure
indicator
Probable
failure
Corrective measures
E02
Lights 1
and 3
blink.
The water
level In
your
machine Is
below
heater.
The
pressure of
your water
supply may
be low or
unstable.
Turn on the tap to the end.
Water supply may be cut, check
It. If the problem still exists,
your machine will automatically
stop after a while. Check water
entry filter: close the tap,
disconnect water entry hose
from the machine, and check If
the filters (net) In the hose and
In the machine are obstructed.
Clean filters If necessary. If the
problem persists, follow ‘for all
failures’ Instructions.
In the case that problem still
continues, unplug your machine,
turn off the tap and consult your
nearest authorized service
provider.______________________
E03
Lights 1
and 4
blink.
The pump
has failed
or the
pump filter
Is
obstructed,
or drain Is
In open
circuit.
Clean the pump filter. If the
problem persists, follow ‘for all
ifallures’ Instructions.
In the case that problem still
continues, consult your nearest
authorized service provider. (*)
E04
Lights 2
and 3
blink.
There Is an
excessive
amount of
water In
your
machine.
Your machine will automatically
drain the water. After your
machine has completed the
draining process. If the problem
persists, follow ‘for all failures’
Instructions.
In the case that problem still
continues, shut down your
machine and unplug. Close the
tap and consult your nearest
authorized service provider.
EOS
Lights 2
and 4
blink.
The heater
of your
machine or
the heat
sensor has
failed.
The scum can become a reason
of this failure. Clean the
machine with a special anti-lime
remedy following the Instructions
on packing. If the problem
persists, follow ‘for all failures’
Instructions.
In the case that problem still
continues, shut down and unplug
your machine. Turn off your tap
and consult your nearest
authorized service provider.______
34