Installation, Removal of transportation screws – Инструкция по эксплуатации Whirlpool AWG 328
Страница 23
Внимание! Текст в этом документе был распознан автоматически. Для просмотра оригинальной страницы Вы можете воспользоваться режимом "Оригинал".
fixation of the door.
• As a result of quality control procedures, a certain amount of water may
remain in your machine.
INSTALLATION
You must pay close attention to the following issues before using your washing
machine.
Removal of transportation screws
•
Transportation screws, which are located at the rear side of the machine,
must be removed before running the machine.
•
Loosen the screws by rotating counter clockwise using a suitable wrench.
(DIAGRAM-1)
• Remove the screws by pulling them. (DIAGRAM-2)
• This will cause the plastic parts located in the interior part of your machine to
drop down under the appliance.
• Lift the machine up slightly to pick up the plastic parts.
•
If all of the plastic parts from the screw groups have not dropped down, open
the door of your machine, move the drum until all plastic parts drop down.
Collect the parts that have fallen to the floor.
•
In the holes where the transport screws have been removed, insert the plastic
transport screw taps found in the accessories bag. (DIAGRAM-3)
• The transportation screws that have been removed from the machine should
be kept safe in the event of future transportation.
DIAGRAM-2
DIAGRAM-1
DIAGRAM-3
21