Инструкция по эксплуатации Sony XR-F5100EE

Fm / am cassette car stereo, Xr-f5100ee

Advertising
background image

Cautions

• This unit is designed for negative earth 12 V

DC operation only.

• Do not get the leads under a screw, or caught

in moving parts (e.g. seat railing).

• Before making connections, turn the car

ignition off to avoid short circuits.

• Connect the power connecting lead 7 to the

unit and speakers before connecting it to the
auxiliary power connector.

Run all earth leads to a common earth

point.

• Be sure to insulate any loose unconnected

leads with electrical tape for safety.

Notes on the power supply lead (yellow)
• When connecting this unit in combination with

other stereo components, the connected car
circuit’s rating must be higher than the sum of
each component’s fuse.

• When no car circuits are rated high enough,

connect the unit directly to the battery.

Parts Iist (1)

• The numbers in the list are keyed to those in

the instructions.

• The bracket 1 and the protection collar 4 are

attached to the unit before shipping. Before
mounting the unit, use the release keys 6 to
remove the bracket 1 and the protection collar
4

from the unit. For details, see “Removing

the protection collar and the bracket (4)” on
the reverse side of the sheet.

Keep the release keys 6 for future use as

they are also necessary if you remove the
unit from your car.

Caution

Handle the bracket 1 carefully to avoid injuring
your fingers.

Note
Before installing, make sure that the catches on
both sides of the bracket
1 are bent inwards 2 mm.
If the catches are straight or bent outwards, the unit
will not be installed securely and may spring out.

Connection example (2)

Notes (2-A)
• Be sure to connect the earth lead before

connecting the amplifier.

• If you connect an optional power amplifier and do

not use the built-in amplifier, the beep sound will
be deactivated.

Tip (2-B-

)

For connecting two or more CD/MD changers, the
source selector XA-C30 (optional) is necessary.

Connection diagram (3)

A

To AMP REMOTE IN of an optional power
amplifier
This connection is only for amplifiers. Connecting
any other system may damage the unit.

B

To the interface cable of a car telephone

Warning

If you have a power aerial without a relay box,
connecting this unit with the supplied power
connecting lead 7 may damage the aerial.

Notes on the control leads
• The power aerial control lead (blue) supplies +12 V

DC when you turn on the tuner .

• When your car has built-in FM/AM aerial in the

rear/side glass, connect the power aerial control
lead (blue) or the accessory power input lead (red)
to the power terminal of the existing aerial
booster. For details, consult your dealer.

• A power aerial without a relay box cannot be used

with this unit.

3-262-935-41

(1)

Installation/Connections

Установка/Подсоединение

FM/AM
Cassette Car
Stereo

XR-F5100EE

© 2004 Sony Corporation

Printed in Thailand

1

2

Ч

4

3

7

4

6

8

1

5

Ч

2

Equipment used in illustrations (not supplied)
Аппаратура, фигурирующая в иллюстрациях (не прилагается)

Front speaker
Передний
громкоговоритель

Rear speaker
Задний
громкоговоритель

Power amplifier
Усилитель

BUS AUDIO IN

BUS CONTROL IN

2

1

Catch

Active subwoofer
Aктивный
низкочacтотный
гpомкоговоpитeль

Rotary commander RM-X4S
Повоpотный
диcтaнционный
пepeключaтeль RM-X4S

A

B

AUDIO OUT REAR

CD/MD changer
Проигрыватель CD/MD

BUS AUDIO IN

BUS CONTROL IN

Source selector*
Селектор источника*

* not supplied

не прилагается

Advertising