Installation, Before using your refrigerator, Warning – Инструкция по эксплуатации Sharp SJXE35PMSL

Страница 12: When transporting

Advertising
background image

12

3

Remove the 2 screws of the lower part of the cabinet

and use these screws to set the foot cover. (At first, the

foot cover is inside the refrigerator compartment.)

NOTE

• Place your refrigerator to access the plug.

• Keep your refrigerator out of direct sunlight and do not place

next to heat generating appliance.

• Do not place your refrigerator directly on the ground. Provide

suitable stand.

• To insert the power plug when the door is opened, door alarm

sounds but it is not abnormal. This sound stops when closing

the door.

Before using your refrigerator

Clean the inside parts with a cloth soaked in warm water.

If soapy water is used, wipe it off thoroughly with water.

INSTALLATION

WARNING

■ Do not install the refrigerator in a damp or wet

location. It may cause the damage to the insulation

and a leak. Dew may also appear on the outer cabinet

and it causes rust.

■ Connect the earth pin to the earth terminal properly.

When transporting

• The casters allow the refrigerator to move back and forth.

• Carry the refrigerator by holding the handles located on the

rear and the bottom.

• Wipe up water in the evaporating pan. Before wiping up

the water, wait more than 1 hour after pulling out the plug

because refrigeration cycle equipment is extremely hot.

(The evaporating pan is located on the rear of the product.)

rear

bottom

Free standing type

2

Use the two front Adjustable feet to place the refrigerator

flatly and firmly on the floor.

Foot cover

Screw (2 screws)

Adjustable foot

1

Keep adequate ventilation space around the refrigerator.

• The figure shows the minimum required space for

installing the refrigerator. The measurement condition

of power consumption is conducted under a different

space dimension.

• By keeping greater space, the refrigerator may be

operated under a less amount of power consumption.

• If using the refrigerator in the smaller space dimension

than the below figure, it may cause the temperature

rise in the unit, loud noise and failure.

• The space between the rear of the refrigerator and the

wall should be 60mm or more and less than 75mm.

If the space is wider than 75mm, you may get injured

by touching compressor and its peripheral parts which

are extremely hot during the operation.

60mm

or more

60mm

or more

90mm

or more

1330 mm

1160 mm

Overall space required in use

Evaporating pan

Casters

SJ-XE35PM:2pcs.

SJ-XP39PG, SJ-XE39PM:

4pcs.

(B803).indb 12

2017/02/17 14:53:30

Advertising
Эта инструкция подходит к следующим моделям: