Инструкция по эксплуатации Pioneer DEH-1310
Deh-1310
Внимание! Текст в этом документе был распознан автоматически. Для просмотра оригинальной страницы Вы можете воспользоваться режимом "Оригинал".
Installation
<ENGLISH>
DEH-1310
Note:
•
Before finally installing the unit, connect the
wiring temporarily, making sure it is all connect
ed up properly, and the unit and the system work
properly.
•
Use only the parts included with the unit to ensure
proper installation. The use of unauthorized parts
can cause malfunctions.
•
Consult with your nearest dealer if installation
requires the drilling of holes or other modifica
tions of the vehicle.
•
Install the unit where it does not get in the dri
ver’s way and cannot injure the passenger if there
is a sudden stop, like an emergency stop.
•
The semiconductor laser will be damaged if it
overheats, so don’t install the unit anywhere hot
— for instance, near a heater outlet.
If installation angle exceeds 60° from horizontal,
the unit might not give its optimum performance.
(Fig. 1)
Installation with the rubber bush
Holder
After inserting the holder into the dash
board, then select the appropriate tabs
Fig.i
Fig. 2
Removing the Unit
This product conforms to new cord colors.
Провода в этом изделии имеют новые цвета.
Printed in Belgium
<CRD3285-A/JS> ЕЕ <KKYLL/00G00000>
Insert the supplied extraction keys
into the unit, as shown in the figure,
until they click into place. Keeping
the keys pressed against the sides
of the unit, pull the unit out.
Fig.3
Installation
<ENGLISH>
DEH-1310
Note:
•
Before finally installing the unit, connect the
wiring temporarily, making sure it is all connect
ed up properly, and the unit and the system work
properly.
•
Use only the parts included with the unit to ensure
proper installation. The use of unauthorized parts
can cause malfunctions.
•
Consult with your nearest dealer if installation
requires the drilling of holes or other modifica
tions of the vehicle.
•
Install the unit where it does not get in the dri
ver’s way and cannot injure the passenger if there
is a sudden stop, like an emergency stop.
•
The semiconductor laser will be damaged if it
overheats, so don’t install the unit anywhere hot
— for instance, near a heater outlet.
If installation angle exceeds 60° from horizontal,
the unit might not give its optimum performance.
(Fig. 1)
Installation with the rubber bush
Holder
After inserting the holder into the dash
board, then select the appropriate tabs
Fig.i
Fig. 2
Removing the Unit
This product conforms to new cord colors.
Провода в этом изделии имеют новые цвета.
Insert the supplied extraction keys
into the unit, as shown in the figure,
until they click into place. Keeping
the keys pressed against the sides
of the unit, pull the unit out.
Fig.3
Printed in Belgium
<CRD3285-A/JS> EE <KKYLL/00G00000>