Appliance self-test, Starting the appliance self-test, Switch off the appliance and wait 5 minutes – Инструкция по эксплуатации Bosch KGE39AI30R Цвет Фронт из нержавеющей стали с покрытием AntiFingerPrintбоковые поверхности - chrome-inox-metallic Дисплей и управление на двери прибора
Страница 20: The self-test programme starts, Ending the appliance self-test
en
20
Appliance self-test
Your appliance features an automatic
self-test program which shows you
sources of faults which may be repaired
by customer service only.
Starting the appliance self-test
1. Switch off the appliance and wait
5 minutes.
2. Switch on the appliance and within the
first 10 seconds hold down a super
button, Fig.
2/8 or 10, for
5-10 seconds until the second
warning signal sounds.
The self-test programme starts.
When the self-test ends and a warning
signal sounds twice, your appliance is in
working order.
If the alarm button
2/5 flashes and
5 acoustic signals sound, there is a fault.
Inform customer service.
Ending the appliance self-test
When the programme has ended, the
appliance switches over to normal
operation.
Fault
Possible cause
Remedial action
Freezer compartment
temperature display
flashes. Fig.
2/3
Warning signal sounds
The Alarm button is lit.
Fig.
2/5
The freezer
compartment is too
warm!
The frozen food
is at risk of thawing!
To switch off the warning signal,
press the Alarm button 5.
Appliance is open.
Close the appliance.
Ventilation openings
have been covered.
Ensure that there is adequate
ventilation.
Too much food was
placed in the freezer
compartment at once.
Do not exceed max. freezing
capacity.
When the fault has been eliminated,
the Alarm display goes out shortly
afterwards.
Freezer compartment
temperature display
flashes. Fig.
2/3
A fault caused
the freezer
compartment
to become too warm
in the past.
When the alarm button 5 is pressed,
the temperature display stops
flashing. Fig.
2/3
The temperature display indicates
for 5 seconds the warmest
temperature which was reached
in the freezer compartment.